Abstract:Aiming to solve the partial discharge problem caused by defects in composite insulators, most existing live detection methods are limited by the subjectivity of human judgment, the difficulty of effective quantification, and the use of a single detection method. Therefore, a composite insulator defect diagnosis model based on acoustic–electric feature fusion and a multi-scale perception multi-input of stacked auto-encoder (MMSAE) network is proposed in this paper. Initially, during the withstanding voltage experiment, the electromagnetic wave spectrometer and ultrasonic detector were used to collect and process the data of six types of composite insulator samples with artificial defects. The electromagnetic wave spectrum, ultrasonic power spectral density, and n-S map were then obtained. Then, the network architecture of MMSAE was built by integrating a stacked auto-encoder and multi-scale perception module; the feature extraction and fusion methods of the electromagnetic wave spectrum and ultrasonic signal were investigated. The proposed method was used to diagnose test samples, and the diagnostic results were compared to those obtained using a single input source and the artificial neural network (ANN) method. The results demonstrate that the detection accuracy of acoustic–electric feature fusion is greater than that of a single feature; the accuracy of the proposed method is 99.17%, which is significantly higher than the accuracy of the conventional ANN method. Finally, composite insulator defect diagnosis software based on PYQT5 and Keras was developed. Ten 500 kV aging composite insulators were used to validate the effectiveness of the proposed method and design software.

THz Wave Defect Detection Technology Based on Attention Autoencoder and Semisupervised Ladder Network

Terahertz Defect Detection Method Based on Significant Spectral Feature Fusion and Spiking Neural Network

THz Wave Detection of Gap Defects Based on a Convolutional Neural Network Improved by a Residual Shrinkage Network

Iterative Online Fault Identification Scheme for High-Voltage Circuit Breaker Utilizing a Lost Data Repair Technique

Defect Detection of Electrical Insulating Materials Using Optically Excited Transient Thermography and Deep Autoencoder.

Detection of Small Defects in Composite Insulators Using Terahertz Technique and Deconvolution Method

Composite Insulator Defect Identification Method Based on Acoustic–Electric Feature Fusion and MMSAE Network

Weak Feature Defect Detection of Insulators Considering Class Boundaries and Interclass Dependencies

Terahertz Imaging Method for Composite Insulator Defects Based on Edge Detection Algorithm.

Two-stream Convolutional Neural Network for Non-Destructive Subsurface Defect Detection Via Similarity Comparison of Lock-in Thermography Signals

Terahertz-Based Insulation Delamination Defect Inspection of Vehicle Cable Terminals

Deep Architecture for High-Speed Railway Insulator Surface Defect Detection: Denoising Autoencoder With Multitask Learning

Study on Detection of Insulator Defects in Time Domain Terahertz Wave

Research on Cable Insulation Layer Defect Detection Based on Terahertz Technology

Defect Identification Detection Research for Insulator of Transmission Lines Based on Deep Learning

Defect Insulator Detection Method Based on Deep Learning

Detection of Double-layer Air Gap Defects Based on Terahertz Imaging Method

Quantitative Detection of Interfacial Air Gap in Insulation Equipment Based on Terahertz Wave Contrast Method

Nondestructive Internal Defect Detection Using a CW–THz Imaging System in XLPE for Power Cable Insulation

Deep Learning Image-Based Defect Detection in High Voltage Electrical Equipment

Detection Method for Metal Impurities and Interlayer Moisture in Power Insulation Equipment by Terahertz Technology