Abstract:The construction of hydropower stations has been expanding in China as a result of economic development and the improvement of people's lives. To save cost, the capacity of a single unit has been greatly increased, and many higher technical requirements have been presented for hydropower units, among which one of the key technologies is the thrust bearing. With the increase in single machine capacity, the pv value of the kinetic energy on the thrust bearing also increases, which will cause the bearing tile burning accident. Therefore, the thrust bearing needs to be designed to improve the bearing capacity. Instead of improving the traditional mechanical structure and using new materials, this paper proposes a levitation load reduction device for the thrust bearing to reduce the pv value of the kinetic energy on the thrust bearing. On the basis of kinetic energy analysis, the feasibility of the magnetic levitation load reduction device is analyzed. A repulsive maglev load reduction device suitable for hydropower units is designed; according to linear motor theory, a three-dimensional analytical model is established to analyze the levitation force, and an analytical calculation method is given. A finite element simulation model is built to study the effects of the primary electrical parameters, structural parameters, and material properties on electromagnetic forces, and the effect rules and the methods of optimal design are given. A small-scale prototype was developed, then tests were conducted to verify the feasibility and accuracy of the design and mechanism.

Optimized Design of Levitation Current Regulator for Bearingless Motor

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Active Disturbance Rejection Control for Bearingless Permanent-Magnet Slice Motor Based on Nonlinear Phase-Locked Loop Observer

Eccentricity Compensation for Bearingless Motor Based on the Tracking of the Minimum Anti-Eccentric Levitation Current

Study on Design and Control of Permanent-Magnet-type Bearingless Motor

Levitation control of an improved modular bearingless switched reluctance motor

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

OPTIMIZED AIR-GAP-FLUX ORIENTATED CONTROL OF AN INDUCTION-TYPE BEARINGLESS MOTOR

Levitation Mechanism and Air-Gap-Flux Orientated Control of the Induction-type Bearingless Motor

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Active Control of Bearing Force Transmissibility for Active Magnetic Bearings-rigid Rotor Systems

High Integrated Methodology and Evaluation for Switched-Reluctance Type Bearingless Motors with Five Degree of Freedom Magnetic Levitation

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

A Modified Deadbeat Predictive Current Control for Improving Dynamic Performance of PMSM

Study on Inverter-fed Three-pole Active Magnetic Bearing

Analytical Optimization of the Bearing Voltage of Motor Considering the Thickness of Insulating Coating: an Improved Equivalent Circuit Model

Design Oriented Analysis of Discrete-Time Current Regulator Design for Low Carrier Ratio Sensorless High-Speed Permanent Magnet Synchronous Machine Drives

Modeling and Analysis of Radial Levitation and Axial Reluctance Force for Four Degree of Freedom Bearingless Switched Reluctance Motor

Design and Optimization of a Magnetic Levitation Load Reduction Device for a Hydropower Unit

Improved Compound Vibration Suppression Control for Magnetic Levitation Motor