A clean process for chloridion removal from manganese sulfate electrolyte using bismuthyl sulfate

Baiqi Sun,Xuheng Liu,Weifeng Liu,Duchao Zhang,Lin Chen,Tianzu Yang

DOI: https://doi.org/10.1016/j.hydromet.2020.105508

IF: 4.217

2020-12-01

Hydrometallurgy

Abstract:<p>In this study, a novel, efficient, and eco-friendly method is proposed to precipitate Cl⁻ as BiOCl from MnSO₄ electrolyte using (BiO)₂SO₄ as the chloride removal agent. The effects of different factors on the transformation and activation of Cl⁻ removal agent, chloride precipitation, recovery and recycling, and purification processes were investigated. Increasing the L/S ratio could promote transformation and activation, while low temperature and low pH could have positive effects on Cl⁻ precipitation. Under optimal conditions, the chloride removal efficiency reached 95.25% and the concentration of Cl⁻ remaining in the electrolyte was reduced to 43.96 mg/L. Following the recovery and recycling process, the recycled agent (BiO)₂SO₄ worked well for Cl⁻ precipitation; subsequently, chloride open this circuit as HCl. In purification process, manganese powder was used to reduce the concentration of Bi³⁺ that remained in the electrolyte to avoid the introduction of new elements. Thus, the concentration of Bi³⁺ was reduced from 125.00 mg/L to 1.80 mg/L, and the reduced bismuth could be returned to the transformation and activation of Cl⁻ removal agent process. This entire process involving the main elements in the reactions followed a repeatable procedure, as shown in the schematic, wherein 99.98% of bismuth could be recycled and 95.25% of chloride opened the circuit in the form of HCl.</p>

metallurgy & metallurgical engineering