Abstract:<p>Laser shock peening (LSP) is an emerging technique for effectively forming metal sheets due to its ability to produce higher and deeper compressive residual stress than conventional shot peening. Because it is crucial to understand the evolution of through-thickness residual stress in peening formed components, the purpose of this research was to investigate the correlation between forming deformation and altered residual stress fields in laser-peened Al7055-T7751 plates of distinct thickness. The effect of geometry thickness on global deformation and through-thickness residual stress was investigated experimentally. First, the global deformation and surface residual stress were measured and compared quantitatively. Additionally, the through-thickness of the residual stress was determined using the slitting technique, and the measurements were validated using X-ray diffraction (XRD). The experimental results indicated that the spatial distribution of the residual stress in the laser-peened plate was the superposition of the LSP-induced elastoplastic stress and the elastic bending stress. Geometry thickness not only affected bending stiffness and macroscopic deformation but also played a significant role in the evolution of residual stress across the entire section. Under the identical peening conditions, a 3-mm plate inherited a 0.5-mm compression layer with approximately 180–280 MPa stress magnitude, whereas a 9-mm plate inherited a 1-mm compression layer with approximately 340–480 MPa of stress magnitude. Further analysis revealed that the elastic bending across the section had a certain compensation effect on the compressive stress of the peened surface. Thick plates (6–9 mm) tended to inherit consistent plane stress states because they demonstrated a relatively small deformation compatibility due to the high stiffness.</p>

Investigation on the deformation progress and residual stress of Ti-6Al-4V alloy during laser shock peening

Laser shock peened Ti-6Al-4 V alloy: Experiments and modeling

Experimental and Numerical Studies of Fatigue Behavior of Ti6Al4V Alloy Treated by Laser Shock Peening

Unraveling Residual Stress Distribution Characteristics of 6061-T6 Aluminum Alloy Induced by Laser Shock Peening

Formation mechanism of residual stress hole under different pulse durations and shock pressure distributions in Ti6Al4V alloy during laser peen texturing

Molecular dynamics simulation of microstructural evolution and mechanical behavior of titanium alloy subjected to laser shock peening

Laser Shock Peening of Ti6Al4V Alloy with Combined Nanosecond and Femtosecond Laser Pulses

Formation Mechanism and Control Method of Residual Stress Profile by Laser Shock Peening in Thin Titanium Alloy Component

The effects of laser peening on laser additive manufactured 316L steel

Experimental research on global deformation and through-thickness residual stress in laser peen formed aluminum plates

Microstructure evolution and mechanical properties of a lamellar near-α titanium alloy treated by laser shock peening

Gradient microstructure and foreign-object-damaged fatigue properties of Ti6Al4V titanium alloy processed by the laser shock peening and subsequent shot peening

Mechanical properties and strengthening mechanisms of Ti-6Al-4V treated by electro-pulsing assisted laser shock peening

Microstructural evolution and mechanical behaviors of Al-Cu-Li alloy processed by laser shock peening

Studies on Laser Shock Peening on Nanomechanical and Mechano-Chemical Properties of Titanium Alloy (Ti6Al4V)

Residual Stress Distribution and Microstructure at a Laser Spot of AISI 304 Stainless Steel Subjected to Different Laser Shock Peening Impacts

On the Microstructure, Residual Stress and Fatigue Performance of Laser Metal Deposited TC17 Alloy Subjected to Laser Shock Peening

Experimental and numerical investigation on residual stress of 316L SS treated by different laser shock peening parameters

Numerical Simulation on Laser Shock Peening of B4C-TiB2 Composite Ceramics

Magnetic Field‐Assisted Laser Shock Peening of Ti6Al4V Alloy

Unveiling the origins of work-hardening enhancement and mechanical instability in laser shock peened titanium