Abstract:This study presents a comparison of the performance of machine learning (ML) techniques, specifically multi-dimensional gene expression programming (MGEP), tensor basis neural network (TBNN), and also proposes a novel universally interpretable machine learning architecture to model the turbulent scalar flux (UIML-s) to enhance turbulence models for fluid flows at different Prandtl numbers in channels with complex shapes of walls in the channel cross section. In particular, peripheral subchannels of rod bundles are of primary interest. However, the accuracy of mean velocity and scalar distributions predicted by commonly used turbulence models still poses a challenge compared to data extracted from high-fidelity eddy-resolving numerical simulations, particularly for engineering applications involving complex geometry flows. In the present study, by utilizing an explicit algebraic expression for the nonlinear Reynolds-stress term obtained through both the evolutionary MGEP optimization and TBNN, the secondary flow structure has been adequately predicted in the cross-wise mean velocity distributions in the square duct and the rectangular channel with three longitudinal rods. This structure is also observed in the data from the concurrent runs performed by direct numerical simulation (DNS) but is completely absent in the results produced by a baseline Reynolds-averaged Navier–Stokes (RANS) closure, which employs the linear eddy viscosity model for the Reynolds stress tensor. Comparison of MGEP and TBNN has shown their nearly equal performance in a square duct flow; however, MGEP works better for the more complex geometry channel with three rods. Furthermore, based on the velocity field produced by the RANS-MGEP model, the ML modification of the gradient diffusion hypothesis, integrated into the aforementioned novel RANS-ML model called as UIML-s, significantly improves the mean scalar distributions in a flow with three bumps serving as a prototype for the peripheral subchannel of rod bundle. The normalized root mean squared error decreases from 13.5% to 7.6%, bringing the predicted distributions closer to the DNS data, particularly in the near-wall region. Another approach, MGEP-s, also yields the acceptable results, which are nearly identical to those from UIML-s. These findings highlight the potential of using data-driven calibration of turbulence models with nonlinear closures to enhance the predictability for RANS simulations of fluid flows, heat, and mass transfer in channels with complex geometry.

Development of turbulent heat flux model for unsteady forced convective heat transfer of small-to-medium Prandtl-number fluids based on deep learning

Heat Flux Prediction of Radiation Balance Wall by Deep Convolutional Neural Networks

Numerical Prediction of Transitional Features of Turbulent Forced Gas Flows in Circular Tubes with Strong Heating

Data-driven turbulence modeling for fluid flow and heat transfer in peripheral subchannels of a rod bundle

Prediction of Forced Gas Flows in Circular Tubes at High Heat Fluxes Accompanied by Laminarization

Interpretable deep learning for prediction of Prandtl number effect in turbulent heat transfer

Revisiting Tensor Basis Neural Network for Reynolds stress modeling: Application to plane channel and square duct flows

Surrogate modeling of heat transfers of nanofluids in absorbent tubes with fins based on deep convolutional neural network

Modeling of Forced Convection in Low-Prandtl-Number Fluids Using a Novel Local Algebraic Heat Flux Model

Revisiting Tensor Basis Neural Networks for Reynolds stress modeling: application to plane channel and square duct flows

Physics-informed graph convolutional neural network for modeling fluid flow and heat convection

Inversion learning of turbulent thermal diffusion for film cooling

Transfer learning model to predict flow boiling heat transfer coefficient in mini channels with micro pin fins

Prediction of turbulent heat transfer using convolutional neural networks

Comprehensive study of flow boiling modeling inside helical micro-finned tubes: Empirical, non-convex optimization and deep learning predictive models

A Comprehensive Evaluation of Turbulence Models for Predicting Heat Transfer in Turbulent Channel Flow across Various Prandtl Number Regimes

Reduced order modelling of natural convection of nanofluids in horizontal annular pipes based on deep learning

Development and Assessment of an Isotropic Four-Equation Model for Heat Transfer of Low Prandtl Number Fluids

Two-dimensional transient heat transfer model of moving quenching jet based on machine learning

Forecasting small scale dynamics of fluid turbulence using deep neural networks

Large eddy simulations of wall jets with coflow for the study of turbulent Prandtl number variations and data-driven modeling