Abstract:A novel segmented control strategy for selenization environment is introduced to regulate the selenization reaction by controlling the evaporation area of Se. This selenization method helps to promote element homogenization, optimize surface smoothness, and obtain a high‐crystalline‐quality absorber with low‐point defects. And the CZTSSe solar cell with a PCE of 13.77% is successfully achieved. High‐crystalline‐quality absorbers with fewer defects are crucial for further improvement of open‐circuit voltage (VOC) and efficiency of Cu2ZnSn(S,Se)4 (CZTSSe) solar cells. However, the preparation of high‐quality CZTSSe absorbers remains challenging due to the uncontrollability of the selenization reaction and the complexity of the required selenization environment for film growth. Herein, a novel segmented control strategy for the selenization environment, specifically targeting the evaporation area of Se, to regulate the selenization reactions and improve the absorber quality is proposed. The large evaporation area of Se in the initial stage of the selenization provides a great evaporation and diffusion flux for Se, which facilitates rapid phase transition reactions and enables the attainment of a single‐layer thin film. The reduced evaporation area of Se in the later stage creates a soft‐selenization environment for grain growth, effectively suppressing the loss of Sn and promoting element homogenization. Consequently, the mitigation of Sn‐related deep‐level defects on the surface and in the bulk induced by element imbalance is simultaneously achieved. This leads to a significant improvement in nonradiative recombination suppression and carrier collection enhancement, thereby enhancing the VOC. As a result, the CZTSSe device delivers an impressive efficiency of 13.77% with a low VOC deficit.

Regulating Hetero‐Nucleation Enabling Over 14% Efficient Kesterite Solar Cells

Controlling Selenization Equilibrium Enables High-Quality Kesterite Absorbers for Efficient Solar Cells

Segmented Control of Selenization Environment for High‐Quality Cu2ZnSn(S,Se)4 Films Toward Efficient Kesterite Solar Cells

A precisely regulating phase evolution strategy for highly efficient kesterite solar cells

Controlling selenization equilibrium enables high-quality Cu2ZnSn(S, Se)4 absorbers for efficient solar cells

Suppressing Deep-Level Trap Toward over 13% Efficient Solution-Processed Kesterite Solar Cell

Synergistic Crystallization Modulation and Defects Passivation in Kesterite via Anion-Coordinate Precursor Engineering for Efficient Solar Cells

Microenvironment Created by SnSe2 Vapor and Pre‐Selenization to Stabilize the Surface and Back Contact in Kesterite Solar Cells

Kesterite Cu2znsn(S,Se)(4) Solar Cells with Beyond 8% Efficiency by A Sol Gel and Selenization Process

Suppressing Surface and Bulk Effect Enables High Efficiency Solution-Processed Kesterite Solar Cells

Precursor Solution Chemistry Via Water Additive Enabling CZTSSe Solar Cells with over 12％Efficiency

Unveiling the Selenization Reaction Mechanisms in Ambient Air-Processed Highly Efficient Kesterite Solar Cells

Coordination Engineering of Cu-Zn-Sn-S Aqueous Precursor for Efficient Kesterite Solar Cells

Effects of Selenization Conditions on Microstructure Evolution in Solution Processed Cu2ZnSn(S,Se)(4) Solar Cells

Controllable Double Gradient Bandgap Strategy Enables High Efficiency Solution‐Processed Kesterite Solar Cells

The enhancement of CZTSSe solar cell performance through active construction of the double-layer absorber

Multinary alloying for facilitated cation exchange and suppressed defect formation in kesterite solar cells with above 14% certified efficiency

Enhancing the performance of Cu<sub>2</sub>ZnSnS<sub>4</sub> solar cell fabricated via successive ionic layer adsorption and reaction method by optimizing the annealing process

Optimization of the Selenization Pressure Enabling Efficient Cu 2 ZnSn(S,Se) 4 Solar Cells

Optimization of the Selenization Pressure Enabling Efficient Cu2ZnSn(S,Se)4 Solar Cells

A Solvothermal Route to Synthesize Kesterite Cu2ZnSnS4 Nanocrystals for Solution-Processed Solar Cells