Abstract:Predicting the melt pool's various characteristics and developing a reliable correlation between these melt pool characteristics and powder bed fusion (PBF) process parameters is crucial for controlling microstructure, alloy micro-segregation, residual stress, and defects in additive manufacturing (AM) of advanced alloys. A three-dimensional, high-fidelity model has been developed to accurately simulate the dynamic behavior and shape of the melt pool, allowing for precise prediction of the melt pool's various characteristics. These characteristics include temperature gradient, cooling rate, liquid phase time, melt pool lifetime, and speed of the solidification front. Various scanning speeds, including 200, 500, 800, 1000, and 1200 mm/s, were considered to gain a clear understanding of their influence on the morphology and characteristics of the melt pool. To ensure a valid and objective evaluation regarding the impact of scanning speeds on the melt pool shape and characteristics, it was deemed appropriate to maintain consistent maximum temperature for each scanning speed by regulating the input laser power accordingly. At high scanning speeds the melt pool morphology was observed to be a typical "parabolic-shaped profile", whereas at the lowest scanning speed (200 mm/s), a distinct deeper rounded "T-shaped profile" formed which is attributed to the enhanced convective heat transfer. Liquid phase time and melt pool lifetime were found to decrease with increasing scanning speed up to 800 mm/s, after which they were almost steady. Temperature gradient and cooling rate were found to rise dramatically with increasing scanning speed. The speed of the solidification front varies significantly over the melt pool area, which indicates a significant consequence for the resulting microstructure. Correlating these characteristics with the employed process parameters for precise control of microstructure, micro-segregation, and residual stress in PBF is critical for the future advancement of next generation, location-specific AM design protocols.

Mitigation of lack of fusion defects in powder bed fusion additive manufacturing

Defects and anomalies in powder bed fusion metal additive manufacturing

Defect and Distortion in Powder Bed Fusion of Metal Additive Manufacturing Parts

Investigation of the Effect of Artificial Internal Defects on the Tensile Behavior of Laser Powder Bed Fusion 17–4 Stainless Steel Samples: Simultaneous Tensile Testing and X-Ray Computed Tomography

Analytical Probabilistic Modeling of Additive Manufacturing-Induced Process Defects and Experimental Validation

A Novel Framework of Developing a Predictive Model for Powder Bed Fusion Process

Defects in Metal Additive Manufacturing Processes

Dynamics of pore formation during laser powder bed fusion additive manufacturing

Concurrent modeling of porosity and microstructure in multilayer three-dimensional simulations of powder-bed fusion additive manufacturing of INCONEL 718

Physics-Based Modeling and Predictive Simulation of Powder Bed Fusion Additive Manufacturing Across Length Scales

Three-Dimensional Prediction of Lack-of-Fusion Porosity Volume Fraction and Morphology for Powder Bed Fusion Additively Manufactured Ti–6Al–4V

Integrated modeling to control vaporization-induced composition change during additive manufacturing of nickel-based superalloys

Linking Process Parameters with Lack-of-Fusion Porosity for Laser Powder Bed Fusion Metal Additive Manufacturing

Predicting and correlating melt pool characteristics with processing parameters in IN625 powder bed fusion additive manufacturing

Methodology to Determine Melt Pool Anomalies in Powder Bed Fusion of Metals Using a Laser Beam by Means of Process Monitoring and Sensor Data Fusion

A novel high-efficient finite element analysis method of powder bed fusion additive manufacturing

Defects in Metal Additive Manufacturing: Formation, Process Parameters, Postprocessing, Challenges, Economic Aspects, and Future Research Directions

Laser powder bed fusion additive manufacturing of metals; physics, computational, and materials challenges

Predicting Laser Powder Bed Fusion Defects Through In-Process Monitoring Data and Machine Learning

Additive Manufacturing Process Simulation of Laser Powder Bed Fusion and Benchmarks

Laser Powder Bed Fusion: A State-of-the-Art Review of the Technology, Materials, Properties & Defects, and Numerical Modelling