Abstract:Eco-friendly and low-cost layered SnSe2-based materials have been attracting great attention in the thermoelectric field for their intrinsically low thermal conductivity. In this work, we applied AgCl as Cl-dopant and formed Ag-rich precipitates in SnSe2 polycrystals, and their thermoelectric properties were investigated. The results demonstrate that Cl was artificially incorporated into SnSe2 by the substitution of Se atoms, playing as donor centers and thus increasing the carrier concentration by 2 orders of magnitude, leading to a tremendous improvement of the electrical conductivity and power factor. However, Ag atoms hardly enter into the Sn lattice sites and brought about the generation of Ag-rich precipitates. The complicated microstructures with multiple types of defects, such as point defects, boundaries, dislocations, and so on, result in a relatively low lattice thermal conductivity in the AgCl-introduced SnSe2 samples. Additionally, the anisotropic electrical and thermal transport properties were investigated, and the results show that higher ZT values were obtained along the pressing direction in these textured samples because of the significantly suppressed lattice thermal conductivity caused by the enhanced phonon scattering via the interior van der Waals layers. Ultimately, a maximum ZT value of 0.35 was realized at 400 degrees C in the polycrystalline SnSe2 with introduction of 11 mol % AgCl, which is nearly 3 times higher than that value of the pristine counterpart. It demonstrates that the combined effects of Cl-doping, Ag-rich precipitates, and texturing could effectively enhance the ZT value for polycrystalline SnSe2.

Enhanced Thermoelectric Properties of FeSe2 Alloys by Lattice Thermal Conductivity Reduction by Cl Doping

Enhancement of Thermoelectric Performance of Layered SnSe2 by Synergistic Modulation of Carrier Concentration and Suppression of Lattice Thermal Conductivity

Enhanced Thermoelectric Performance of N-Type Bi2o2se by Cl-Doping at Se Site

Enhancing the Thermoelectric Performance of Cu2se Via Ag Doping

Enhanced Thermoelectric Properties in Highly Co-Doped Bi2Se3 by Density-of-State Effective Mass Increase

Enhanced Thermoelectric Properties of Polycrystalline SnSe via LaCl3 Doping

Enhanced thermoelectric performance of n-type polycrystalline SnSe via NdCl3 doping

Cu2−xS and Cu2−xSe Alloys: Investigating the Influence of Ag, Zn, and Ni Doping on Structure and Transport Behavior

Mn-doping method boosts Se doping concentration in Cu2S towards high thermoelectric performance

Synthesis of Fe-Doped Tetrahedrites Cu<sub>12-x</sub>Fe<sub>x</sub>Sb<sub>4</sub>S<sub>13</sub> and Characterization of Their Thermoelectric Properties

The Effects of Chlorine Doping on the Thermoelectric Properties of Bi2O2Se

Enhanced Thermoelectric Performance of Cu2Se Alloys by Simultaneous Engineering of Thermal and Electrical Transport Properties Through S and Te co‐doping

Magnetic Iron Doping in Cu2SnS3 Ceramics for Enhanced Thermoelectric Transport Properties

Enhanced Thermoelectric Performance of Quaternary Cu2-2xAg2xSe1-xSx Liquid-like Chalcogenides

Effect of Se - site Doping on Thermoelectric Properties of Cu2SnSe3 Synthesized by Combustion

Enhanced Thermoelectric Performance of SmS by Se Alloying and Y Doping

Thermoelectric Properties of Cl-Doped Bicuseo Oxyselenides

Ultralow Lattice Thermal Conductivity and Improved Thermoelectric Performance in Cl-Doped Bi2Te3- xSex Alloys

Enhanced thermoelectric properties of iron doped compound (Zn1−xFex)4Sb3

Enhanced Thermoelectric Performance of CuSbSe2 Via Mn Doping

Enhanced thermoelectric properties of FeTe 2 by Sb doping prepared by solid-state reaction