Abstract:As the sand mass flux increases from zero at the leading edge of a saltating surface to the equilibrium mass flux at the critical fetch length, the wind flow is modified and then the relative contribution of aerodynamic and bombardment entrainment is changed. In the end the velocity, trajectory and mass flux profile will vary simultaneously. But how the transportation of different sand size groups varies with fetch distance is still unclear. Wind tunnel experiments were conducted to investigate the fetch effect on mass flux and its distribution with height of the total sand and each size group in transportation. The mass flux was measured at six fetch length locations (0.5, 1.2, 1.9, 2.6, 3.4 and 4.1 m) and at three free-stream wind velocities (8.8, 12.2 and 14.5 m/s). The results reveal that the total mass flux and the mass flux of each size group with height can be expressed by q=aexp(−bh), where q is the sand mass flux at height h, and a and b are regression coefficients. The coefficient b represents the relative decay rate. Both the relative decay rates of total mass flux and each size group are independent of fetch length after a quick decay over a short fetch. This is much shorter than that of mass flux. The equilibrium of the relative decay rate cannot be regarded as an equilibrium mass flux profile for aeolian sand transport. The mass fluxes of 176.0, 209.3 and 148.0 μm size groups increase more quickly than that of other size groups, which indicates strong size-selection of grains exists along the fetch length. The maximal size group in mass flux (176.0 μm) is smaller than the maximal size group of the bed grains (209.3 μm). The relative contribution of each size group to the total mass flux is not monotonically decreasing with grain size due to the lift-off of some small grains being reduced due to the protection by large grains. The results indicate that there are complex interactions among different size groups in the developmental process of aeolian sand transport and more attention should be focused on the fetch effect because it has different influences on the total mass flux, the mass flux profile and its relative decay rate.

Field investigation of the fetch effect and essential conditions for saturated sand flow

TEST OF EMPIRICAL SEDIMENT TRANSPORT RELATIONS AGAINST EXPERIMENTAL SWASH DATA UNDER THE NON-CAPACITY MODELING FRAMEWORK

Experimental Measurement Of Wind-Sand Flux And Sand Transport For Naturally Mixed Sands

Shear Wave Velocity in Sand Considering the Effects of Frequency Based on Particle Contact Theory

Unified Model of Sediment Transport Threshold and Rate Across Weak and Intense Subaqueous Bedload, Windblown Sand, and Windblown Snow

Discrete Element Method simulations of the saturation of aeolian sand transport

Fetch effect on the developmental process of aeolian sand transport in a wind tunnel

Field observations of the vertical distribution of sand transport characteristics over fine, medium and coarse sand surfaces

Granular Pseudo-Fluid Large-Eddy Simulation Study of Aeolian Sand Transport Near a Bed Surface

Fetch‐driven aeolian sediment transport on a sandy beach: A new study

Aeolian Creep Transport: Theory and Experiment

Vertical Distribution of Aeolian Sand Mass Flux Based on Field Observation at Southern Rim of the Taklimakan Desert

Numerical Simulation of Sand Dune Accumulation at Suoyang Ancient City

Measurements of the aeolian sand transport saturation length

A Continuum Saltation Model for Sand Dunes

A Trans-Scale Simulation of Aeolian Sand Flow – Dune – Dune Field Based on Actual Environmental Wind Field

Evolution of Streamwise Sand Transport with Distance

Vertical Profiles of Mass Flux for Windblown Sand Movement at Steady State

Method for estimating overland flow velocity on sandified slopes from measured solute transport process with bias errors

Large Scale Structures of Turbulent Flows in the Atmospheric Surface Layer with and Without Sand