Abstract:Massive high-strength concrete generates significant hydration heat during casting, which indirectly influences the risk of structural cracking by affecting the internal temperature gradient distribution. This paper investigated the effect of layered pouring methods on internal temperature gradients in massive concrete using the precast bent caps of a Shanghai bridge project as a case study. The temperature-time development patterns of each poured layer were studied through three sets of physical experiments. Temperature gradient distribution functions were established to specify the spatial temperature distribution trends of each layer. The interconnectedness between the spatial temperature distributions of adjacent poured layers was explored based on the established distribution functions. Targeted anticracking suggestions for layered poured concrete were provided based on these correlations. Additionally, a novel temperature control measure for managing hydration heat was proposed. The feasibility of this measure was verified through practical experiments. Moreover, corresponding finite element models were established to investigate the influence of parameters such as structural lead, outer wall pipe radius, and cooling water flow rate on the internal temperature field of concrete. The hydration heat-time patterns of the poured layers all showed a skewed single-peak distribution. The hydration heat of odd- and even-numbered layers exhibited different Gaussian distribution patterns in the lateral direction; the correlation between the spatial temperature distributions of adjacent layers could be quantified by the ratio of the standardized variance of the Gaussian distribution function of temperature for each corresponding layer. Implementing temperature control measures at specific reasonable positions and using a natural logarithmic function to calculate the design limits of structural dimensions could effectively prevent structural cracking. The newly proposed hydration heat control measure improved the temperature gradient distribution within the concrete. Reducing the structural lead, increasing the outer wall pipe radius, and increasing the cooling water flow rate all resulted in a decrease in the peak temperature inside the concrete. Finally, a structural lead of 0.4 was recommended for actual construction projects, for which the outer wall pipe radius should not exceed 30 mm.

Concrete with ultra-large volume, high strength and low hydration heat

Optimal Design and Performance of Concrete with Function Component in Marine Environment

Research on massive concrete with high volume of fly ash

Four-function Principle for Optimization Design of Green High Performance Massive Concrete

Development and Application of High Performance Concrete and Ultra-high Performance Concrete

Preparation and Performance of Ultra-high Strength Concrete with Good Toughness

Study on performance of high strength pumping concrete compounded by fly ash composite powder under low water-cement ratio

Mechanical properties and microstructure of ultra-high strength concrete with lightweight aggregate

Mix Design and Engineering Application of C80 High-Performance Silicon Fume Concrete

Research On The Mixture Ratio Design Of Ultra-High Strength Concrete

Hydration and microstructure evolution of a novel low-carbon concrete containing recycled clay brick powder and ground granulated blast furnace slag

Large volume of concrete construction techniques and hydration heat caused cracks precautions

Properties of Concrete with High-Volume Limestone Powder under Low Temperature Conditions

New Development of Concrete Technology——Multifunctional High Performance Concrete

Early-Age Mechanical Characteristics and Microstructure of Concrete Containing Mineral Admixtures under the Environment of Low Humidity and Large Temperature Variation

Design of self-compacting ultra-high performance concrete (SCUHPC) towards to the cementitious materials packing optimization

Design of high-volume fly ash concrete for a massive foundation slab

Investigations of the hydration heat of large-volume precast concrete bent caps using layered pouring and a new temperature control measure

Performance Analysis of High-Performance Concrete Materials in Civil Construction

Hydration, mechanical properties and durability of high-strength concrete under different curing conditions

Hydration and pore structure characteristics of concrete incorporating internal curing materials in a dry and large-temperature-difference environment