Abstract:Intelligent power management system is an important part of the smart grid, in which the non-intrusive load monitoring technology is one of the key technologies. However, most of the load monitoring methods regard this task as a multi-classification problem, thus it is not effective to identify the unknown loads that did not participate in training. In this paper, an adaptive non-intrusive load monitoring method based on feature fusion has been proposed which utilizes both information of harmonic current feature and voltage-current (V-I) trajectory feature. The harmonic current feature is obtained from the high-frequency load sampling data through Fast Fourier Transform (FFT). At the same time, the V-I trajectory feature is obtained by using the pre-trained convolutional autoencoder neural network that was trained for feature extraction on a public dataset. After the feature extraction, the similarity between these two feature vectors and the available feature vectors in the database is calculated by TOPSIS algorithm. Then the load monitoring can be carried out according to the similarity. When the maximum similarity is greater or equal than the set threshold, the load is considered to be one of the existing loads in the database, otherwise, it will be considered as a new type of load, and the load feature database will be updated. The autoencoder model is trained by using the V-I trajectory from the BLUED dataset and the PLAID dataset is used to verify the identification accuracy of the proposed algorithm by comparison with different algorithms. On the PLAID dataset, the identification accuracy can reach above 97%. Finally, on the embedded Linux system with STM32MP1 as the core, some household electrical appliances are used for validation in real house environment. The results show that the proposed method has improved the capability of load identification by using the complementarity of different features. It can be carried out in real time on embedded system and is able to identify the unknown load at the same time.

Research on Non-Intrusive Load Disaggregation Technology Based on VMD–Nyströmformer–BiTCN

A Survey of the Research on Non-intrusive Load Monitoring and Disaggregation

Power Safety Warning Method Based on GM-FHMM Load Decomposition Algorithm

Non-intrusive load disaggregation based on composite deep long short-term memory network

Non-Invasive Load Decomposition Method Based on Multi-Scale TCN and Multi-Head Self-Attention Mechanism

DRA-net: A new deep learning framwork for non-intrusive load disaggregation

Non-intrusive Load Monitoring Based on Equipment Operation State

Adaptive Non-Intrusive Load Monitoring Based on Feature Fusion

Non-Intrusive Load Monitoring with Fully Convolutional Networks

Non-Intrusive Load Monitoring Based on Multiscale Attention Mechanisms

Integrating Graph Signal Processing and Multitask Temporal Convolutional Networks for Household Nonintrusive Load Monitoring

Sequence-to-Sequence Load Disaggregation Using Multiscale Residual Neural Network

CALM: Contactless Accurate Load Monitoring Via Modality Distillation.

Sequence-to-Sequence Load Disaggregation Using Multi-Scale Residual Neural Network

Non-Intrusive Load Monitoring Based on Unsupervised Optimization Enhanced Neural Network Deep Learning

Temporal feature adaptive non-intrusive load monitoring via unsupervised probability density evolution

Research on Non-intrusive Load Monitoring Based on Seq2point Model

A robust non-intrusive load disaggregation method with roof-top photovoltaics

A non-intrusive load decomposition method of resident by multi-scale attention mechanism

Non-intrusive load monitoring method with inception structured CNN

A Deep Learning Technique using Low Sampling rate for residential Non Intrusive Load Monitoring