Abstract:Intelligent power management system is an important part of the smart grid, in which the non-intrusive load monitoring technology is one of the key technologies. However, most of the load monitoring methods regard this task as a multi-classification problem, thus it is not effective to identify the unknown loads that did not participate in training. In this paper, an adaptive non-intrusive load monitoring method based on feature fusion has been proposed which utilizes both information of harmonic current feature and voltage-current (V-I) trajectory feature. The harmonic current feature is obtained from the high-frequency load sampling data through Fast Fourier Transform (FFT). At the same time, the V-I trajectory feature is obtained by using the pre-trained convolutional autoencoder neural network that was trained for feature extraction on a public dataset. After the feature extraction, the similarity between these two feature vectors and the available feature vectors in the database is calculated by TOPSIS algorithm. Then the load monitoring can be carried out according to the similarity. When the maximum similarity is greater or equal than the set threshold, the load is considered to be one of the existing loads in the database, otherwise, it will be considered as a new type of load, and the load feature database will be updated. The autoencoder model is trained by using the V-I trajectory from the BLUED dataset and the PLAID dataset is used to verify the identification accuracy of the proposed algorithm by comparison with different algorithms. On the PLAID dataset, the identification accuracy can reach above 97%. Finally, on the embedded Linux system with STM32MP1 as the core, some household electrical appliances are used for validation in real house environment. The results show that the proposed method has improved the capability of load identification by using the complementarity of different features. It can be carried out in real time on embedded system and is able to identify the unknown load at the same time.

Integrating Graph Signal Processing and Multitask Temporal Convolutional Networks for Household Nonintrusive Load Monitoring

A multi-task learning model for non-intrusive load monitoring based on discrete wavelet transform

Adaptive Non-Intrusive Load Monitoring Based on Feature Fusion

Non-Intrusive Load Monitoring Based on the Combination of Gate-Transformer and CNN

An Improved Temporal Convolutional Network for Non-intrusive Load Monitoring

Integrating Non-Intrusive Load Monitoring Based on Graph-to-point Learning into a Self-Adaptive Home Energy Management System

Multiscale Self-Attention Architecture in Temporal Neural Network for Nonintrusive Load Monitoring.

MATNilm: Multi-Appliance-Task Non-Intrusive Load Monitoring With Limited Labeled Data

Temporal and Spectral Feature Learning with Two-Stream Convolutional Neural Networks for Appliance Recognition in NILM

Subtask Gated Networks for Non-Intrusive Load Monitoring

A Fusion Framework Using Integrated Neural Network Model for Non-Intrusive Load Monitoring

Graph-Based Dependency-Aware Non-Intrusive Load Monitoring.

Non-Invasive Load Decomposition Method Based on Multi-Scale TCN and Multi-Head Self-Attention Mechanism

Low-Rate Non-Intrusive Appliance Load Monitoring Based on Graph Signal Processing

Multivariate Exploration of Non-Intrusive Load Monitoring Via Spatiotemporal Pattern Network

A Non-Intrusive Load Identification Method Based on Novel Data Acquisition Terminals and Model Fusion

Multi-Task Learning-Based Method for Load Identification, Electrical Fault Detection and Signal Denoising

An Ensemble Framework for Short-Term Load Forecasting Based on TimesNet and TCN

Non-Intrusive Load Monitoring Based on Graph Total Variation for Residential Appliances

Temporal feature adaptive non-intrusive load monitoring via unsupervised probability density evolution

MLFGCN: short-term residential load forecasting via graph attention temporal convolution network