Abstract:Finite-element (FE) analysis was used to compare the high-temperature responses of steel columns with two different stress-strain models: the Eurocode 3 model and the model proposed by National Institute of Standards and Technology (NIST). The comparisons were made in three different phases. The first phase compared the critical buckling temperatures predicted using forty seven column data from five different laboratories. The slenderness ratios varied from 34 to 137, and the applied axial load was 20-60 % of the room-temperature capacity. The results showed that the NIST model predicted the buckling temperature as or more accurately than the Eurocode 3 model for four of the five data sets. In the second phase, thirty unique FE models were developed to analyze the W8×35 and W14×53 column specimens with the slenderness ratio about 70. The column specimens were tested under steady-heating conditions with a target temperature in the range of 300-600 °C. The models were developed by combining the material model, temperature distributions in the specimens, and numerical scheme for non-linear analyses. Overall, the models with the NIST material properties and the measured temperature variations showed the results comparable to the test data. The deviations in the results from two different numerical approaches (modified Newton Raphson vs. arc-length) were negligible. The Eurocode 3 model made conservative predictions on the behavior of the column specimens since its retained elastic moduli are smaller than those of the NIST model at elevated temperatures. In the third phase, the column curves calibrated using the NIST model was compared with those prescribed in the ANSI/AISC-360 Appendix 4. The calibrated curve significantly deviated from the current design equation with increasing temperature, especially for the slenderness ratio from 50 to 100.

Numerical simulation of steel-concrete composite beams and slabs at elevated temperatures

Study on the shear behaviour of steel–concrete composite beams after elevated temperature and water cooling

Numerical modeling on concrete structures and steel-concrete composite frame structures

Behaviour of Cold-Formed Stainless Steel Beams at Elevated Temperatures

Numerical simulation of the experimental behavior of RC beams at elevated temperatures

Finite Element Analysis On The Temperature Field Of Steel-Concrete Composite Joints Under Fire

Research On The Behavior Of Composite Frame With Cfst Columns And Composite Beam After Exposure To Fire

A numerical study on a novel demountable cold-formed steel composite beam with profiled steel sheeting

Numerical Simulation of Deformation and Strength of Reinforced Concrete Slabs under Thermal-Mechanical Loads

Experimental and Numerical Study of Temperature Developments of Composite Joints Between Concrete-Encased Concrete-Filled Steel Tube Columns and Reinforced Concrete Beams

Simulation of Mechanical Properties of Special-Shaped Concrete-Filled Steel Tubular Column and Steel Beam Joints after Fire

Modelling of Concrete-Filled Stainless Steel Columns in Fire

Preliminary Study on Post-Fire Behavior of Composite Frame with CFST Columns and Composite Beam

Research on mechanical behavior of steel-concrete composite slabs exposed to overall stage fire

Finite Element Analysis Of Steel-Concrete Composite Slab With Section Steel Ribs

Numerical simulation of fire resistance of steel-concrete continuous composite slab

Preliminary Research on Mechanical Behavior of Composite Frame with Concrete-filled Steel Tubular Columns after Exposure to Overall Stage of Fire

Experimental Study and High-Efficiency Simulation of In-Plane Behavior of Composite Frame Slab

Finite element modelling of profiled steel deck composite slab system with engineered cementitious composite under monotonic loading

INFLUENCE OF MATERIAL MODELS ON PREDICTING THE FIRE BEHAVIOR OF STEEL COLUMNS

Modeling and Investigation of Elasto-Plastic Behavior of Steel–concrete Composite Frame Systems