Abstract:Isostructural alloying has been regarded as an important approach to boosting thermoelectric performance of narrow gap semiconductors through thermal conductivity reduction. However, it does harm to carrier mobilities as well because of atomic disorders. Here, we extend the alloying concept from "isostructural" to "quasi-isostructural", which means that the two alloying components are no longer strictly isostructural but structurally closely related. As a proof-of-concept, a series of cubic Cu2SnSe3–tetragonal Cu3SbSe4 quasi-isostructural alloys (Cu2+xSn1–xSbxSe3+x) were synthesized, and their thermoelectric transport properties were systematically studied. No significant loss of carrier mobilities was found during quasi-isostructural alloying, probably due to the structural similarity of the two end members as well as the negligible mass contrasts between Sn and Sb. Surprisingly, a remarkable reduction of lattice thermal conductivity from 1.2 W m–1 K–1 for Cu2SnSe3/Cu3SbSe4 to 0.4 W m–1 K–1 for Cu5SnSbSe7 at 673 K was observed, which can hardly be explained from a solid solution perspective. Our X-ray photoelectron spectroscopy analysis unambiguously demonstrate the coexistence of Sn2+ and Sn4+ in the alloying systems, whereas Sn simply exhibits Sn4+ in Cu2SnSe3. We deduce that the minute structural changes of Cu2SnSe3 during quasi-isostructural alloying make Sn discordant, leading to its valence state splitting. The mixed-valence scattering therefore strongly impedes phonon propagation beyond alloying. Altogether, a considerably enhanced ZT ≈ 0.4 is realized in the sample with x = 0.2, which is 150% improvement over the x = 0 sample. By selecting the x = 0.5 sample as a representative, a preliminary doping study was performed but seems unsuccessful because of the varying Sn2+/Sn4+ ratio. We expect higher thermoelectric performance in those quasi-isostructural alloys if their carrier concentration can be fully optimized.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsaem.1c01155?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsaem.1c01155</a>.Temperature-dependent heat capacity (Cp), thermal diffusivities (D) and Lorenz number (L) for Cu2+xSn1–xSbxSe3+x (x = 0, 0.2, 0.5, 0.8, and 1.0). The longitudinal (νl) and transverse (νt) acoustic velocities, calculation of average acoustic velocity (vs) (<a class="ext-link" href="/doi/suppl/10.1021/acsaem.1c01155/suppl_file/ae1c01155_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Enhanced thermoelectric performance of Cu2SnSe3 via synergistic effects of Cd-doping and CuGaTe2 alloying

Enhanced Thermoelectric Performance of Cu2SnSe3 by Synergic Effects Via Cobalt-Doping

Enhanced Thermoelectric Performance in Cu2GeSe3 Via (Ag,ga)-Co-doping on Cation Sites

Enhanced Thermoelectric Properties of Cu2SnSe3 by (Ag,In)-Co-Doping

Complex lattice occupation of copper leading to enhanced thermoelectric performance in n-type PbSe

Realizing Enhanced Thermoelectric Properties in Cu2S-alloyed SnSe Based Composites Produced Via Solution Synthesis and Sintering

Large effective mass and low lattice thermal conductivity contributing to high thermoelectric performance of Zn-doped Cu<sub>5</sub>Sn<sub>2</sub>Se<sub>7</sub>

Enhancement of the Thermoelectric Performance of Cu 2 GeSe 3 via Isoelectronic (Ag, S)-co-substitution

Boosting Thermoelectric Performance of Cu 2 SnSe 3 via Comprehensive Band Structure Regulation and Intensified Phonon Scattering by Multidimensional Defects

Toward Ultrahigh Thermoelectric Performance of Cu2SnS3‐Based Materials by Analog Alloying

Enhanced thermoelectric performance of AgCuTe-doped polycrystalline SnSe by lattice plainification

Enhanced Thermoelectric Properties of Cu2SnSe3-Based Materials with Ag2Se Addition

Realizing excellent thermoelectric performance in Ag-doped Cu 2 SnSe 3 -ZnSe solid solution by symmetry modification and stacking promotion

High Thermoelectric Performance of SnTe Via in Doping and Cu1.75Se Nanostructuring Approach

Achieving High Thermoelectric Performance in ZnSe-Doped CuGaTe2 by Optimizing the Carrier Concentration and Reducing Thermal Conductivity

Quasi-isostructural Alloying of Cu 2 SnSe 3 –Cu 3 SbSe 4 toward Higher Thermoelectric Performance

Boosting thermoelectric performance of SnTe by selective alloying and band tuning

Enhancing the Thermoelectric Performance of Cu2se Via Ag Doping

Enhanced Thermoelectric Performance of N‐Type PbSe Through Semi‐Coherent Nanostructure by AgCuTe Alloying

Realizing High Thermoelectric Performance of Ag/Al Co‐Doped Polycrystalline SnSe through Band Structure Modification and Hydrogen Reduction

Enhanced thermoelectric properties of Cu-Se system via bond-structure adjustment by Ag-doping