OPTIMIZATION OF KEY PARAMETERS IN STRUVITE (K) PRODUCTION FOR PHOSPHORUS AND POTASSIUM RECOVERY USING A BATCH CRYSTALLIZER

M. Tauviqirrahman,S. Muryanto,A. P. Bayuseno,D. Perwitasari,J. Jamari
DOI: https://doi.org/10.31788/RJC.2019.1225125
RASAYAN Journal of Chemistry
Abstract:Struvite (K) precipitation can be used for recovering the valuable nutrients, mainly phosphorus (P) and potassium (K) from wastewater. In this study, the key parameters controlling its precipitation in a batch crystallizer, namely temperature (30-40 OC), stirring rate (200-400 rpm), citric acid concentration (1-20 ppm) were optimized using SRM (surface response methodology) for yielding the optimum mass of the struvite (K) crystal. The XRPD Rietveld method confirmed that struvite (K) and impurity of sylvite (KCl) were precipitated from the pH solution of 9. The most significant factor corresponding to the yield response was predicted by SRM to be temperature, while the stirring rate and the citric acid concentration are insignificant factors contributing to the optimal mass yields. The optimum mass of precipitates (14.682 mg) was obtained, when the precipitation process was set at the temperature of 39 OC, a stirring rate of 376 rpm and citric acid concentration of 2.2350 ppm. These parameters would be the best design factors for yielding the optimum struvite (K) crystal with the purity of more than 99 wt. %.
Chemistry,Materials Science,Environmental Science
What problem does this paper attempt to address?