Abstract:The common mode voltage (CMV) has been extensively investigated as a significant issue under balanced voltage conditions. However, in practical applications, voltage asymmetry caused by load imbalance can lead to an increase in the magnitude of CMV. Therefore, in the presence of load imbalance, it is necessary to adjust the arrangement of switch state to control the output voltage, and redesign the CMV suppression strategy. To overcome these issues, this article proposes a general modulation aimed at suppressing CMV in two cases: balance and unbalanced load. Compared with traditional space vector modulation (SVM), the proposed modulation can reduce the peak of CMV to approximately 43.3%–50% under the balanced load and 50% under the unbalanced load. In addition, although three-dimensional SVM (3-D SVM) is a common modulation strategy for four-leg inverters, it suffers from computationally complex problems in its implementation. Therefore, a simplified method is proposed based on 3-D SVM. After being simplified, the calculation time of the modulation can be reduced. Then, a comprehensive comparison is conducted between the proposed and other modulation strategies. Finally, a four-leg CSI is built in the laboratory. Experimental and simulation results verify the effectiveness of the proposed method under balanced and unbalanced load conditions.

Common Mode Suppression Method of Current Source Back-to-Back Converter Based on Five-Segment Space Vector Modulation

Common-Mode Voltage Reduction with Improved Output Voltage for Three-to-Five-Phase Indirect Matrix Converters

Review on Pulse-Width Modulation Strategies for Common-Mode Voltage Reduction in Three-Phase Voltage-Source Inverters

A Common-Mode Voltage Reduction Method for a Back-to-back Four-Level Hybrid-Clamped Converter

Common-mode Voltage Analysis and Suppression in Five-Level Modular Composited Converter

Common-Mode Current Suppression of Transformerless Nested Five-Level Converter with Zero Common-Mode Vectors

Common-Mode Voltage Reduction for Back-to-Back Two-Level Converters Based on Zero-Sequence Voltage Injection

A New Space Vector Modulation Strategy to Reduce Common-Mode Voltage for Quasi-Z-Source Indirect Matrix Converter

A Common-Mode Voltage Elimination Scheme by Reference Voltage Decomposition for Back-to-Back Two-Level Converters

A Common-Mode Voltage Elimination Approach Based on Modulation Signal Decomposition for the Three-Level Back-to-Back Converter

The Common-Mode Voltage Suppression Method for PMSM Based on Current Predictive Control

A Soft-Switching Current-Source-Inverter-Fed Motor Drive With Reduced Common-Mode Voltage

Space Vector Modulation Method for Simultaneous Common Mode Voltage and Circulating Current Reduction in Parallel Three-Level Inverters

Control Strategy with A Generalized Dc Current Balancing Method for Multimodule Current-Source Converter

Generalized Modulation of Common Mode Voltage Reduction for Current Source Inverter in Balanced and Unbalanced Load Cases

Common-Mode Voltage Reduction Method for Three-Level Inverter With Unbalanced Neutral-Point Voltage Conditions

CMV Suppression Method for Back-to-Back Three-level NPC Converter

Suppression of Common-Mode Voltage for Matrix Converter Based on SVPWM

Modulation strategy to reduce common-mode voltage for three-to-five phase indirect matrix converter

A virtual space vector modulation strategy for suppressing common-mode voltage in dual-output T-type three-level converters

A Modulation Method to Eliminate Common-mode Voltage of Dual Three-Phase Motor