Abstract:The ten-switch inverter is recently proposed in the literature to replace the neutral clamped point three-level inverter; it can produce a two/three-level output voltage using only ten switches. The conventional modulation strategies generate a large common mode voltage (CMV), which increases the leakage current. The use of the sinusoidal pulse width modulation (SPWM) produces a high CMV of V dc /2. On the other hand, using conventional space vector modulation (SVM) methods can only reduce the CMV to V dc /3. To achieve further reduction in the magnitude of the CMV, a new virtual SVM (VSVM) strategy is suggested. The space vector diagram is constructed with virtual vectors which can generate the lowest possible CMV (| V CM |= V dc /6). In the proposed VSVM, the action times are calculated and the switching sequence is synthesized for each region. The VSVM is applied to a ten-switch inverter through a simulation, and it is validated experimentally. It is compared to some existing modulation techniques, such as the SPWM method, two SVM methods and the conventional VSVM. Simulation and experimental results showed that the proposed VSVM algorithm can effectively reduce CMV to V dc /6. The use of virtual vectors does not affect the performance of the proposed algorithm in terms of the use of the DC bus voltage. In addition, it can effectively balance the neutral point voltage. However, the analysis of voltages and currents demonstrated that the use of virtual vectors increases the rate of harmonics compared to conventional SVM methods.

Space Vector Modulation Method for Simultaneous Common Mode Voltage and Circulating Current Reduction in Parallel Three-Level Inverters

Generalized Space Vector Modulation for Ripple Current Reduction in Quasi-Z-Source Inverters

Review on Pulse-Width Modulation Strategies for Common-Mode Voltage Reduction in Three-Phase Voltage-Source Inverters

Integrated Modulation of Dual-Parallel Three-Level Inverters With Reduced Common Mode Voltage and Circulating Current

Zero-Sequence Voltage Modulation Strategy For Multiparallel Converters Circulating Current Suppression

Common-Mode Voltage Reduction Method for Three-Level Inverter With Unbalanced Neutral-Point Voltage Conditions

Space Vector Modulation for SiC & Si Hybrid Active Neutral Point Clamped Converter

A virtual space vector modulation strategy for suppressing common-mode voltage in dual-output T-type three-level converters

ZSCC suppression method for parallel three-level inverters based on model predictive control with virtual location vector

Hybrid varied virtual vector modulation method of parallel three-level inverter considering neutral point potential and phase current balance

Common Mode Voltage Reduction and Neutral-Point Voltage Balance for Quasi-Z-Source Three-Level Neutral-Point-Clamped Inverters

Generalized Space-Vector-Modulation Method for Soft-Switching Three-Phase Inverters

Novel Simple Multilevel Space Vector Modulation Method for Cascade Inverter

A New Virtual Space Vector Modulation Technique Applied to the Ten-Switch Inverter for Common Mode Voltage Reduction

Generalized Modulation of Common Mode Voltage Reduction for Current Source Inverter in Balanced and Unbalanced Load Cases

Integrated Modulation of Dual-Parallel NPC Inverters With Eliminated CMV

High Efficient Common-Mode Current Suppression Svm Method for Three-Phase Three-Level Transformer-Less Photovoltaic Inverters

A New Space Vector Modulation Strategy to Reduce Common-Mode Voltage for Quasi-Z-Source Indirect Matrix Converter

Common-Mode Voltage Reduction and Neutral Point Voltage Balance Modulation Technology of Quasi-Z-Source T-Type Three-Level Inverter

Eliminating Common-Mode Voltage Spikes in Three-Phase Inverters Through 12-Section Space-Vector Modulation

Synchronized CBPWM Strategy with Optimized Common-Mode Voltage for Three-Level Inverter at Low Carrier Ratio