Abstract:In the heat balance of buildings, the main heat loss occurs through enclosing structures. Determining the heat transfer coefficients on the exterior facades of buildings is not an easy procedure, as they depend on a wide range of parameters: wind speed in the surface atmosphere, wind direction relative to the orientation of facades, surface orientation relative to wind, surface angle relative to the ground plane, type terrain, the impact of adjacent buildings, surface texture, surface and air temperature differences, surface size and aspect ratio, etc. The paper presents the results of a numerical study of heat transfer from the outer surfaces of separately located structures in the surface layer of the atmosphere. Schematic models of the building have the same heat transfer surface area, but different heights and lengths. CFD-modeling of heat transfer of buildings in the wind flow in a three-dimensional setting allowed to establish some features of heat transfer of enclosing structures depending on the height of the building and the characteristics of the wind flow. In particular, it is shown that the average surface values of heat flux density increase with increasing building height. The results of the calculation of the average heat flux density on the surface of buildings indicate its dependence on the height of this building. This dependence is observed only for houses with a height of less than 30 m. For taller houses, this dependence is insignificant. The local values of heat transfer coefficients on the windward and leeward facades of the building obtained as a result of modeling indicate incorrect application of heat transfer coefficient values αк = 23 W / (m2 ∙ K) for construction practice for external surfaces of enclosing structures. For windward facades, a polynomial model for the heat transfer coefficient is more suitable, and for leeward ones, the Frank formula for αk.

Full-scale measurements of convective coefficient on external surface of a low-rise building in sheltered conditions

Measurements of wind speed and convective coefficient on the external surface of a low-rise building

Determination of exterior convective heat transfer coefficient for low-rise residential buildings

Field Measurement of the Convective Heat Transfer Coefficient on Vertical External Building Surfaces Using Naphthalene Sublimation Method

A Novel Method for Full-Scale Measurement of the External Convective Heat Transfer Coefficient for Building Horizontal Roof

Numerical simulation of wind pressures on low-rise hip roofed buildings

High-resolution CFD simulations of forced convective heat transfer coefficients at exterior building surfaces

Numerical study of wind-driven rain distribution on low-rise buildings with different roof styles

CFD Simulation of Convective Heat-Transfer Coefficient of External Surfaces of Buildings

Field Measurements Of The Convective Heat Transfer Coefficients Of Impervious Surfaces In The Urban Area

Field measurement of outside convective heat transfer coefficient on horizontal roof using naphthalene sublimation technique

Field Measurement of Convective Heat Transfer on External Surface of Building Using Naphthalene Sublimation Method

Experimental Investigation into Convective Heat-Transfer Characteristics of Horizontal Roof of Building

Method for Evaluating of the Convective Heat Transfer of Window for the Non-Uniform Radiator Heated Environment

Numerical Assessment of Convective Heat Transfer Coefficients in Buildings Conditioned by Parallel Split Systems

Measurement of the convective heat transfer coefficient of the human body in the lift-up design

Surface heat transfer coefficients in building envelopes: Uncertainty levels in experimental methods

Performance Investigation of Convective and Radiant Heat Removal Methods in Large Spaces

Temperature Field Simulation of Building Envelopes

Influence of architectural features of buildings on heat losses from their facades

Co-cooling, simulation-based exploration of a new method to measure the heat transfer coefficient of a building envelope in hot climate and summer period