Abstract:The vector control of the permanent magnet synchronous motor (PMSM) is affected by cross-coupling, output delay, parameter mismatch, and other factors; thus, resulting in its poor steady-state and insufficient dynamic performance. To address these problems, the design proposed in this study adopts a model predictive current control strategy. In the traditional model predictive control, the absolute value of the difference between the predicted output current of the inverter and the reference current is used as the cost function instead of the minimum value of the valence function, i.e., the optimal solution of the system, and the best switching state is outputted. The design proposed in this study adopts the dual-vector model to predict the current control. Firstly, the reference voltage vector was predicted on basis of the deadbeat idea, which reduced the calculation burden of processor. Next, in order to further improve the stability of the system, a two-vectors duty cycle calculation method was introduced. Then, simplifies the selection range of the two voltage vectors. While ensuring the accuracy of the voltage vector, the control is reduced. Reduce the amount of calculation in the system, thereby improving its robustness. Finally, based on the principle of current vector tracking error minimization, the duration of the selected voltage vector was determined. Last but not the least, the control strategy is applied to the MTPA control to increase the operating efficiency of the control motor. The improved control strategy can effectively reduce the torque ripple and improve the dynamic and steady-state performance of the system. Simulation results verify the feasibility and effectiveness of the proposed control algorithm.

Model Predictive Torque Control for Dual Three-Phase PMSM based on Novel Virtual Voltage Vector

A Sequential Direct Torque Control Scheme for Seven-Phase Induction Machines Based on Virtual Voltage Vectors

An Improved Model Predictive Torque Control for PMSM Drives Based on Discrete Space Vector Modulation

Synthetic Vectors-Based Predictive Control of Dual Three-Phase PMSMs for Current Harmonics Mitigation Considering Average Deception Effect

Torque Ripple Suppression Control for Dual Three-Phase Permanent-Magnet Synchronous Motor

Deadbeat Model-Predictive Torque Control With Discrete Space-Vector Modulation for PMSM Drives

A Novel Torque Ripple Reduction Strategy for Predictive Direct Torque Controlled Pmsg

Three-Vector-Based Model Predictive Torque Control for a Permanent Magnet Synchronous Motor of EVs

An Effective Direct Torque Control Based on Space Vector Modulation for DTP-PMSM

Novel Virtual-Finite-Control-Set-Based Model Predictive Torque Control of Five-Phase PMSM With Enhanced Third Harmonic Current Suppression

Finite Control Set Model Predictive Torque Control With Reduced Computation Burden for PMSM Based on Discrete Space Vector Modulation

Multi-Virtual-Vector Model Predictive Current Control for Dual Three-Phase PMSM

Two-Vector-Based Model Predictive Torque Control Without Weighting Factors for Induction Motor Drives

Model Predictive Torque Control of Surface Mounted Permanent Magnet Synchronous Motor Drives with Voltage Cost Functions

Adaptive Torque Ripple Suppression Methods of Three-Phase PMSM During Single-Phase Open-Circuit Fault-Tolerant Operation

Model predictive flux control for permanent magnet synchronous motor

MTPA control of permanent magnet synchronous motor based on dual-vector model predictive control

An Improved Model Predictive Direct Torque Control Strategy for Reducing Harmonic Currents and Torque Ripples of Five-Phase Permanent Magnet Synchronous Motors.

Efficient Predictive Control for Dual Three-Phase PMSM Drive With Vector Transformation

An Error Tracking Dead-beat Model Predictive Torque Control for Open-Winding Permanent Magnet Synchronous Motor with Common DC Bus

Predictive Torque Control for PMSM Based on Weighting Factor Elimination and Fast Voltage Vector Selection