Abstract:Noise from rail transit viaducts often has a negative effect on surrounding buildings and nearby residents. To reduce the bridge vibration and radiated noise, floating slab tracks have been widely adopted in rail transit viaducts. To calculate the vibration of coupled track-bridge systems, both time-domain and frequency-domain methods can be applied although their relative performance is not very clear. This study aims to compare the two approaches and then provide some guidelines in choosing the appropriate method for predicting the vibration. The principle and methodology of the two calculation methods are firstly introduced, and the models for the train, floating slab track and bridge are developed using similar parameters. To further improve the efficiency and accuracy of the frequency-domain method, a half period method and a weighted average method are proposed to calculate the average responses of a certain point on the rail, floating slab and bridge to approximate the response during the pass-by. An indirect method is used to estimate the wheel–rail combined roughness from the measured rail acceleration when the train is running on the bridge, and compared with the direct measurement rail roughness. For the vibration of the bridge and floating slab, comparisons are made between results obtained from the time-domain and frequency-domain methods with different train speeds, and between results from experiment and simulation with different roughness. It is found that the wheel–rail contact forces and other structural responses from the two approaches show good consistency in the frequency region above 20 Hz. It is shown that a good approximation of the response during the pass-by can be obtained using the frequency-domain method by adopting the half period average or a simplified weighted average of two wheel position cases. When using the measured roughness and estimated roughness, the simulated vibration of the floating slab and bridge match well with the experimental results, and the indirect method can be used to modify direct measurement roughness in lower frequency regions. In the vibration prediction, the rail vibration or roughness, and other parameters in the vehicle–track–bridge system, should be measured accurately to ensure high reliability.

Combining iterative modal strain energy method with BEM-SEA to predict structural noise from railway composite bridge damped with CLD

Dynamic Monitoring and Data Analysis of a Long-Span Arch Bridge Based on High-Rate GNSS-RTK Measurement Combining CF-CEEMD Method

A Numerical Method for Analyzing the Low-Frequency Noise of Bridge under Vehicle Load

Study on low-frequency noise radiated from steel multi-box girder bridge induced by traffic vibration

Dynamic Receptance Analysis Combined with Hybrid FE-SEA Method to Predict Structural Noise from Long-Span Cable-Stayed Bridge in Urban Rail Transit

Assessment on Transient Sound Radiation of a Vibrating Steel Bridge Due to Traffic Loading

Theoretical analysis of low-frequency noise radiated from bridge vibrations

Effect of Rail Restraints on Seismic Responses of Cushioning Railway Bridges

Applying constrained layer damping to reduce vibration and noise from a steel-concrete composite bridge: An experimental and numerical investigation

Analysis on Low-Frequency Noise Induced by Vehicle-Bridge Coupling Vibration

Prediction and analysis of structural noise of a box girder using hybrid FE-SEA method

Iterative eigenvalue method coupled with RSM for structural acoustic analysis and optimization of the CLD-damped orthotropic steel deck

Analysis of Dynamic Behavior for Ballastless Track-Bridge with a Hybrid Method

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Control Mechanism and Noise Reduction Effect of CVDM on Rail Transit Steel Bridge: Experimental and Numerical Study

Vibration Characteristics of Damping Pad Floating Slab on the Long-Span Steel Truss Cable-Stayed Bridge in Urban Rail Transit

A simplified method to assess vehicle–bridge interaction for train-induced vibration of light-weight railway bridges

Comparison of time-domain and frequency-domain models for vibration prediction of a rail transit viaduct paved with floating slab track

Efficient simulation of stochastic seismic response of long-span bridges in river valleys using hybrid BEM-FEM

High-resolution frequency domain decomposition for modal analysis of bridges using train-induced free-vibrations

Low-frequency noise radiation from traffic-induced vibration of steel double-box girder bridge