Abstract:Wall-detached continuous rotating detonation (CRD) was experimentally and numerically achieved in the designed hollow chamber. For this novel CRD wave, the pressure signals measured at the chamber wall showed lower peak pressure but much higher frequency when compared with typical wall-attached CRD. Meanwhile, the high-speed photographs showed that the luminous area (i.e. coupled reaction zone) of this CRD wave always varied within a "wall-detached" cylindrical zone. Experimental results with different ribs further proved that the CRD wave propagated within a cylinder whose diameter was about 44 mm, and the corresponding propagation velocity was very close to that of C-J detonation. A model was proposed to illustrate the flow field structure of this special CRD. According to the annular injection position of propellants, the hollow chamber was divided into two parts, namely, central CRD zone and outer shock wave zone. The detonation wave propagated within the former zone and the induced oblique shock waves stretched in both of the two zones. These two waves rotated synchronously to form the basic flow field structure of this wall-detached CRD. This model was further verified by a premixed numerical simulation case. The wall-detached propellants injection was believed to contribute to the formation and self-sustaining of the detonation wave in the center, and the oblique shock waves were induced on both sides due to the lateral expansion effect. This study shows that the detonation wave could rotate spontaneously and continuously without the support of chamber wall. The analyses on the propagation characteristics as well as the flow field structure of wall-detached CRD contribute to the understanding of self-sustaining mechanism of CRD wave in the hollow chamber.

Initiation process of non-premixed continuous rotating detonation wave through Schlieren visualization

Hydrogen-air, ethylene-air, and methane-air continuous rotating detonation in the hollow chamber

Propagation of rotating detonation wave with wall-detached injection in a hollow combustor

Propagation and flow field analysis of wall-detached continuous rotating detonation wave in a hollow combustor

Numerical Study on Detonation Initiation Process in a Reverse Ignition Boosted Detonation Chamber

Research on the Influence of Reflected Shock Wave on Continuously Rotating Detonation Engine

Shock Wave and Flame Front Induced Detonation in a Rapid Compression Machine

Investigating Rotating Detonation Mode Fueled by Precombustion Cracking Gas

Experimental investigation on spray and detonation initiation characteristics of premixed/non-premixed RDE

A numerical study of the rapid deflagration-to-detonation transition

Experimental research on initiation characteristics of a rotating detonation engine

Investigation of rotating detonation fueled by the pre-combustion cracked kerosene

Analysis on the radial structure of rotating detonation wave in a hollow combustor

Experimental Research on Self-Initiation Process of Rotating Detonation Wave by High-Temperature Ethylene-Rich Gas

Propagation behavior of rotating detonation waves with premixed kerosene/air mixtures

Numerical simulations and theoretical analysis of the forward shock wave in a non-premixed air-breathing rotating detonation combustor

Characterization of wave modes in a kerosene-fueled rotating detonation combustor with varied injection area ratios

Visual experimental research on the propagation instabilities in a plane-radial rotating detonation engine

Detonation re-initiation mechanism following the Mach reflection of a quenched detonation

Analysis of Waves Dynamics in a Rotating Detonation Combustor Fueled by Kerosene

Effects of Inner Cone Length on Continuous Rotating Detonation in a Variable Cross-section Combustor