A general DBEM for mixed-mode cohesive crack problems

Sérgio G.F. Cordeiro,Gustavo O. Daumas,Francisco A.C. Monteiro

DOI: https://doi.org/10.1016/j.tafmec.2023.104249

IF: 4.374

2024-01-13

Theoretical and Applied Fracture Mechanics

Abstract:This work proposes a general dual boundary element method (DBEM) for cohesive mixed-mode crack problems. Local cohesive stiffnesses are defined to yield the boundary element nonlinear equations for any mixed-mode cohesive model in a direct way. The main novelty resides on the fact that the formulation can take into account all possible cohesive surface conditions: (i) contact, (ii) softening, (iii) unloading/reloading and (iv) complete failure, which may occur independently of the chosen cohesive model. Besides, the well-established Park-Paulino-Roesler (PPR) model was incorporated into DBEM methods. The tangent matrix of the discrete model is explicitly derived and the solution is sought by a proper degree-of-freedom (DOF) control method. The proposed formulation is validated reproducing mode I and mode II patch-tests. Some other relevant problems, including a mixed-mode fracture test, are also presented to demonstrate that the above conditions are essential to reproduce complex mixed-mode cohesive fractures. The results also shown that the control of a monotonically increasing DOF yields reliable solutions in problems with snap instabilities. In order to facilitate the validation of the method, predefined crack paths were assumed in the examples. Further developments may include incorporating arbitrary crack growth and damage-based cohesive models for fatigue crack growth analysis.

engineering, mechanical,mechanics