Abstract:A DC current sensing method is developed by introducing the controllable sensitivity. The prototype sensor is implemented by inserting a transverse-transverse (T-T) mode disk-type magnetoelectric (ME) laminate into the air gap of a C-shaped ferrite magnetic concentrator to measure a wide range DC current. The equivalent circuit model of the ME laminate containing interface coupling factor, which physically reflects the strain transfer between the phases, has been further applied in DC current sensing under both low and resonant frequency excitation in this paper. The theoretical analysis results indicate that the DC current sensitivity is controllable by setting the quiescent operating point on the d(31,m)-H-bias curve of Terfenol-D and the excitation frequency of the ME laminate, respectively. Under 1 Oe AC magnetic field drive at 1 kHz, the DC current sensitivity dV(ac)/dI(dc) of this DC current prototype sensor is 0.058 mV/A, equivalently 0.124 mV/Oe over the range of 0-500 A. Under resonant frequency AC magnetic drive, the current sensitivity dV(ac)/dI(dc), = 2.38 mV/A, equivalently 5.12 mV/Oe over the same current range, considerably higher than that reported in previous DC ME sensor literatures. The experimental results provide a potential strategy for realizing wide-range DC current sensing in real applications. For lower current measurement, this ME based DC sensor should be operated under resonant excitation to obtain a high voltage output, while for higher current, it can be switched to be operated at a proper quiescent operating point under non-resonant frequency for an acceptable output. (C) 2018 Elsevier B.V. All rights reserved.

A DC to 25 MHz Current Sensing Interface for Hall-effect Sensor

AlGaN/GaN 2-D Electron Gas for Highly Sensitive and High-Temperature Current Sensing

A Programmable Low Power Current Source for Bioimpedance Measurement: Towards a Wearable Personalized Health Assistant.

Temperature, Sensitivity, and Frequency Response of AlN/GaN Heterostructure Micro-Hall Effect Sensor

Design and Implementation of High-Precision Current Measurement Instrument Based on Hall Sensor

A Hall Sensor Microsystem for Current Measurement Used in Watt-Hour Meter.

Contactless Current Measurement for Enclosed Multiconductor Systems Based on Sensor Array.

High-resolution Current Sensor Utilizing Nanocrystalline Alloy and Magnetoelectric Laminate Composite

A CMOS Front-End Hall Sensor Microsystem for Linear Magnetic Field Measurement With Best Tradeoff Between Sensitivity and SNR

Noninvasive Current Sensor for Multicore Cables

Design of Small Hall Current Sensor of Intelligent Module with Thyristor

Current Measurement Using Hall-effect Sensing Chip and Over-sampling Technique for AC Motor Drives

Simulation and optimization of conductor structural parameters of free-space hall-effect current sensor

A Wide-Range DC Current Sensing Method Based on Disk-Type Magnetoelectric Laminate Composite and Magnetic Concentrator

Cascoded GaN half-bridge with 17 MHz wide-band galvanically isolated current sensor

A Wide Range Dc Current Sensor Based On Disk-Type Magnetoelectric Laminate Composite With A Feedback Circuit

A CMOS Hall sensor modeling with readout circuitry and microcontroller processing for magnetic detection

A 3-D GaAs-based Hall Sensor Design With Dual Active Layers Structure

Non-Invasive Integrated Device for Multi-Core Cable Current Measurement Based on TMR Sensor Array

Low Field Optimization of a Non-Contacting High-Sensitivity GMR-Based DC/AC Current Sensor

A Passive Sensing-Wireless Transmitting Scheme Demonstrated by Integrating a Magnetic Cantilever With a Microstrip Patch for DC Current Monitoring