Abstract:316 stainless steel (SS) was coated with CoCrFeNiNbx (x: atomic ratio, x = 0, 0.1, 0.2, and 0.3) high entropy alloy coatings (HEACs) by laser cladding (LC). The impacts of Nb content on the phase composition, microstructure, microhardness, wear resistance and corrosion properties of CoCrFeNi based HEACs were examined. Different from the canonical dendritic (DR) - interdendritic (ID) microstructure presented by the other three HEACs, the ID of Nb0.3 HEACs also existed nanoscale Nb-rich Laves phase composed of Nb-Ni and Nb-Co. The inclusion of Nb significantly reduced the average grain size of CoCrFeNi based HEACs from 59.43 mu m to 11.38 mu m. It also greatly diminished the formation of high angle grain boundaries (HAGBs), increasing the percentage of low angle grain boundaries (LAGBs) from 31 % to 61 %. The microhardness of Nb-containing HEACs was significantly promoted due to the solid solution strengthening and fine grain strengthening caused by large size Nb atoms. Affected by Laves phase with high coordination number and space filling ratio and higher proportion of LAGBs, the microhardness of Nb0.3 HEAC was even as high as 530 HV. The increase in Nb concentration also strengthened the HEACs' resistance to wear. Nb0, Nb0.1, Nb0.2, and Nb0.3 HEACs had corresponding specific wear rates of 0.36, 0.32, 0.23, and 0.20 mm3/Nm. Unlike 316 SS, Nb0 and Nb0.1 HEACs, which had both adhesive wear and abrasive wear, Nb0.2 and Nb0.3 HEACs were mainly wear by abrasive wear. The corrosion behavior of CoCrFeNiNbx HEACs in 0.5 M H2SO4 solution was similar to 316 SS, but the corrosion resistance was stronger than 316 SS. Nb0.3 HEAC with the Ecorr of -164 mV and Icorr of 6.40 x 10-7 A/cm2 showed the best acid corrosion resistance, which could be attributed to the stable and dense passivation film on its surface. Distinct from the intergranular corrosion of other coatings, the corrosion of Nb0.3 HEAC mainly occurred in DR, because the FCC phase acted as the anode site in it when FCC and Laves phase co-existed.

The effect of Nb content on microstructure and properties of laser cladding 316L SS coating

Electrochemical Corrosion Behavior in Sulfuric Acid Solution and Dry Sliding Friction and Wear Properties of Laser-Cladded CoCrFeNiNb High Entropy Alloy Coatings

Effect of Nb content on microstructure and corrosion resistance of Inconel 625 coating formed by laser cladding

Effects of CeO2 on the Microstructure and Properties of Laser Cladding 316L Coating

Effects of Nb content on the microstructure and properties of CoCrFeMnNiNb x high-entropy alloy coatings by laser cladding

Effect of the Nb content on the microstructure evolution and properties of the CrFeCoNiNb x layers prepared by laser cladding

Effect of Y2O3 Content on Microstructure and Corrosion Properties of Laser Cladding Ni-Based/WC Composite Coated on 316L Substrate

Effect of Nb Content on Phase Transformation and Comprehensive Properties of TiNb Alloy Coating

Effect of niobium content on microstructure and wear and corrosion resistance of laser-clad FeCo0.5CrNi1.5B0.5Nbx coatings on ductile iron

The Microstructure and Properties of Laser-Cladded Ni-Based and Co-Based Alloys on 316L Stainless Steel

Effect of W Content on Microstructure and Properties of Laser Cladding CoCrFeNi HEA Coating

Microstructure and properties of laser clad Fe-based amorphous alloy coatings containing Nb powder

Effect of Al content on wear and corrosion resistance of Ni-based alloy coatings by laser cladding

Effect of Different Particles Distribution on Microstructure and Corrosion Resistance of Nickel-Base Laser Cladding Coatings

Effect of Nb Content on the Tribological Properties of Laser-Cladded Ti-Al-C MAX Phase Composite Coatings

Effect of process parameters and niobium carbide addition on microstructure and wear resistance of laser cladding nickel‐based alloy coatings

Effect of Fe content on microstructure and corrosion resistance of Ni-based alloy formed by laser cladding

Effect of Heat Treatment on Microstructure and Tribocorrosion Performance of Laser Cladding Ni-65 WC Coating

Influence of Nb on the microstructure of laser clad composite coating reinforced by in-situ particles

Microstructure and Wear Characteristics of Laser-Clad CoCrFeMnNiNb0.3 High-Entropy Alloy Coating

Effect of NbC in-situ synthesis on the microstructure and properties of pre-placed WCoB-TiC coating by laser cladding