Abstract:H 2 production from renewable bio-oil is a promising way to supply green hydrogen; however, this technology suffers from the high viscosity, high corrosiveness, and complex compositions of the bio-oil. Thus, in the present study, we propose a novel method that converts real biomass pyrolysis vapors into H 2 via a chemical looping process. Fe–Al–Ni composite oxide pellets were prepared in a simple and industrial way and then used as the oxygen carrier (OC), and their redox activity and cycle stability were assessed in a fixed-bed reactor system under different conditions with pine sawdust volatiles as the fuel. The results indicated that the Fe–Al–Ni composites exhibited nearly 99% CO 2 selectivity in the reduction stage and high H 2 purity (>98%) in the H 2 production stage when the redox temperature was higher than 850 °C. X-ray diffraction (XRD) analysis of the Fe–Al–Ni composite oxide pellets at different bed layers indicated that Fe 2 O 3 can be reduced to FeO by sawdust pyrolysis vapors, and an inert spinel phase of Fe–Al–O was formed concurrently. Coke deposited on the OC would hinder reduction, thereby decreasing the fuel conversion and H 2 energy efficiency, but it can be improved by increasing the pyrolysis temperature. Long cycling tests showed that a relatively stable H 2 energy efficiency of 20% and a H 2 purity of 98% could be obtained in whole tests; nevertheless, the conversion of CH 4 declined rapidly after 25 cycles, which could be attributed to the interior sintering, iron migration to the outer surface and garnet phase (Al 3 Fe 5 O 12 ) formation of the OC according to the scanning electron micrograph, micro texture, and XRD analysis of the OC with different cycling tests.

Algae Pyrolysis in Molten NaOH-Na 2 CO 3 for Hydrogen Production

Algae pyrolysis in alkaline molten salt: Products transformation

Alkaline pyrolysis of anaerobic digestion residue with selective hydrogen production

Catalytic Pyrolysis of Microalgae for Production of Aromatics and Ammonia

Pyrolysis of Algal Biomass: Determination of the Kinetic Triplet and Thermodynamic Analysis.

Low-temperature Alkaline Pyrolysis of Sewage Sludge for Enhanced H2 Production with In-Situ Carbon Capture

Hydrogen Production from Steam Gasification of Tableted Biomass in Molten Eutectic Carbonates

Fast Pyrolysis of Microalgae Remnants in a Fluidized Bed Reactor for Bio-Oil and Biochar Production

One-step pyrolysis-catalytic hydrogen production by the oleaginous microalga Chromochloris zofingiensis

Molten Salt-Enhanced Production of Hydrogen by Using Skimmed Hot Dross from Aluminum Remelting at High Temperature

Solar pyrolysis of algae in molten salt for capacitive carbon preparation

Catalytic pyrolysis of natural algae over Mg-Al layered double oxides/ZSM-5 (MgAl-LDO/ZSM-5) for producing bio-oil with low nitrogen content

Alkali metal bifunctional catalyst-sorbents enabled biomass pyrolysis for enhanced hydrogen production

Pyrolysis of macroalgae biomass from Nitella hyalina and its thermokinetics

High-purity hydrogen production from real biomass pyrolysis vapors via a chemical looping process

Molten salt pyrolysis of biomass: The evaluation of molten salt

Hydrogen-rich Energy Recovery from Microalgae (Lipid-Extracted) Via Steam Catalytic Gasification

Catalytic pyrolysis of lignocellulosic and algal biomass using NaOH as a catalyst

Hydrothermal Liquefaction of Macroalgae Enteromorpha prolifera to Bio-oil

Synergistic effects of lanthanum ferrite perovskite and hydrogen to promote ammonia production during microalgae catalytic pyrolysis process

Biomass source influence on hydrogen production through pyrolysis and in line oxidative steam reforming