Abstract:A quasi-distributed fiber magnetic field sensing system based on frequency-shifted interferometry fiber cavity ringdown (FSI-FCRD) technique is proposed and demonstrated. In this scheme, multiple sensing units are connected in series in a frequency-shifted interferometer, and share one continuous-wave light source, one slow detector and one low-frequency data collector to lower the cost. In each unit, a side-polished single-mode fiber coated with the diluted water-based ferrofluid serves as the sensing element for enhancing sensitivity and mechanical strength. The cavity loss of each unit varies with the change of applied magnetic field, due to the tunable refractive index of the ferrofluid and the evanescent wave effect of the polished fiber. Therefore, the measurement of magnetic field can be realized by monitoring the cavity loss change. A dual-unit FSI-FCRD magnetic field sensing system was experimentally investigated. The cavity losses and locations of the two sensing units about 2500 m apart were synchronously achieved from a spatial domain ringdown signal of the system. The measured cavity loss of each sensing unit exhibited a good linear relationship with the magnetic field over a range of 0 to 250 Oe. The sensitivities were separately 6.7894 × 10−4 and 7.4980 × 10−4 dB/Oe, with the corresponding detection limits of 2.56 and 3.63 Oe. Through repeated measurements, the obtained baseline stabilities of the two units were 0.15% and 0.18%, respectively. By theoretical analysis, the maximum multiplexing number of sensing units can reach 30 over a 15.8-km distance under the same experimental settings. It indicates that multi-unit FSI-FCRD provides an alternative technique with low cost, high sensitivity and high stability for quasi-distributed magnetic field detection in many fields such as smart grids, biomedicine and national defense.

Phase Shift Fiber Loop Ring-Down Cavity Integrated SNS Structure for Magnetic Field Sensing

A Novel Special Optical Fiber with Magneto-Optic Nonreciprocal Phase Shift under Transversely Applied Magnetic Field

Magnetic field sensing based on fiber loop ring-down spectroscopy and etched fiber interacting with magnetic fluid

Fiber optic magnetic field sensor based on a magnetic-fluid-induced phase-shift FLRD

Multipoint Magnetic Field Measurement Based on Magnetic Fluid and FSI-FLRD

Magnetic-Ionic-Liquid-Functionalized Photonic Crystal Fiber for Magnetic Field Detection

A quasi-distributed fiber magnetic field sensor based on frequency-shifted interferometry fiber cavity ringdown technique

Magnetic Field Measurement Based on the Sagnac Interferometer with a Ferrofluid-Filled High-Birefringence Photonic Crystal Fiber

Magnetic Fluid-Filled Optical Fiber Fabry–Pérot Sensor for Magnetic Field Measurement

Fiber Magnetic Field Sensor With Extended Linear Measuring Range Based on Magneto-Shape Effect

Optical sensor using space-domain active fiber cavity ringdown technique

A Magnetic Field Sensor Based on Directional Coupling in a Magnetic Fluid-Filled Photonic Crystal Fiber

Magnetic Field Measurement Method Based on the Magneto-Volume Effect of Hollow Core Fiber Filled With Magnetic Fluid

Magnetic Field Sensing Based on Whispering Gallery Mode with Nanostructured Magnetic Fluid-Infiltrated Photonic Crystal Fiber

Highly sensitive magnetic field sensors based on Fe2O3 nanorods grown on the surface of a tapered few mode fiber

An ultra-sensitive photonic crystal fiber magnetic field sensor based on Vernier effect using two parallel Sagnac loops

SMF-MMF-SCF-Based Humanoid-Shaped Fiber-Optic Sensor for Wide Range of Magnetic Field Detection

Magnetic Field Sensor Based on Asymmetric Optical Fiber Taper and Magnetic Fluid

High-Sensitivity MF Filled Photonic Crystal Fiber Magnetic Field Sensor Based on Sagnac Interferometer

Magnetic Field Measurement Using Surface Plasmon Resonance Sensing Technology Combined with Magnetic Fluid Photonic Crystal

Fiber Optic All-Polarization Weak Magnetic Field Sensor Based on Sagnac Interferometer