Abstract:The paper presents the methods of assessing the technical condition of varistor surge arresters used in laboratory tests and in operation—performed without disconnecting the arresters from the network. The analysis of the diagnostic methods was supplemented with the results of the measurements of the leakage current of arresters coming directly from their production and used in the power industry. Among the available methods of evaluating the technical condition of arresters, mainly indicator solutions (temperature and operation counter) and the measurement of the selected parameters of the leakage current are used. In the latter, the method of determining the resistive component of the leakage current, determined on the basis of the analysis of the voltage and current waveforms, or only the arrester current, has become widespread. In this type of measurement, current clamps are used in the operation, and additionally, in voltage measurements, voltage transformers are used, where you have to take into account the fundamental, additional sources of errors discussed in the article. These errors and the dispersion resulting from the production technology may fundamentally hinder the proper assessment of the technical condition; hence, it is so important to properly recognize the listed basic sources of measurement uncertainty. In addition, the analysis should take into account three factors related to external conditions: temperature, the voltage applied to the arrester, and the content of higher harmonics in the supply voltage, for which appropriate methods have been provided to determine the active component of the leakage current for reference conditions. This article presents the results of the measurements of the leakage currents of surge arresters measured with various methods.

Development of a Low-Energy Mobile Current Waveform Impulse Generator for Application in Low Voltage Surge Arresters

Impulse Current Generator With Dual Waveform Output and Its Application

A Novel Method for Online Diagnostic Analysis of Partial Discharge in Instrument Transformers and Surge Arresters from the Correlation of HFCT and IEC Methods

Development of a Novel 0~10kV Continuous Adjustable Portable Combination Wave Generator

Quality Assessment of Low Voltage Surge Arresters

Method to Design Surge Generators

The Study of Oscillating Lightning Impulse Voltage Generator for a 110kv GIS Field Test

On the simulation of lightning current for the application in lightning arrester and material ablation tests

Real-Time Impedance Monitoring During Electroporation Processes in Vegetal Tissue Using a High-Performance Generator

A Compact High Voltage Pulse Generator for Bounded-wave EMP Simulator

Experimental and Analytical Investigation of the Effects of Single and Multiple Simulated Lightning Impulse Currents on Metal-Oxide Arrester Blocks

Leakage Current Measurements of Surge Arresters

Novel complex waveform generator for evaluation of HVDC station class surge arresters

Modeling the development of low current arcs and arc resistance simulation

Thermal FEM Analysis of Surge Arresters During HVdc Current Interruption Validated by Experiments

Pulse generator with intermediate inductive storage as a lightning simulator

The Circuit Design and Simulation of Continuous Multiple Pulse Impulse Current Generator for Environmental Test of Aircraft Lightning

Research on the Portable 10kv Arrester Test Holder

A Test Method for Response Behavior of Metal-Oxide Arrester Subjected to Transient Electromagnetic Disturbances

A Nanosecond High Voltage Pulse Generator for Measuring Space Charge Distribution

A Current-Pulse Generator with an Intermediate Storage for Inductive-Resistive Load Operation