Abstract:Piezoelectric energy harvesting from roadways, which converts ambient vibration energy of roads into electric energy, has a wide range of potential applications in intelligent transportation systems. On-site open-traffic tests revealed that energy harvested by piezoelectric energy harvester (PEH) units embedded in roadways is far less than the value in laboratories, which may be because the parameters of traffic flow load (frequency, distribution, wave shape, etc.) and the road structure are significantly different from the pre-established conditions in laboratories or even on-site tests with only one vehicle passing. To address this issue, an analytical model for piezoelectric energy harvesting from roadways under open-traffic conditions was proposed to examine the mechanical response of the road structure and the electrical performance of the stack PEH units embedded in the road. The influence of all parameters in the energy-harvesting system was then obtained with the scaling law method, revealing that the energy harvested by PEH units is determined by the energy coefficient, the system's intrinsic parameter, normalized parameters of roadways, and the normalized embedded position of PEH units. It is found that that the energy-harvesting system's intrinsic parameter should be approximately 0.8 to ensure maximum energy-harvesting efficiency. Meanwhile, the pavement with lower bending stiffness and higher linear density while the foundation with small stiffness and smaller damping coefficient would be more suitable for energy harvesting. Furthermore, the lateral embedded position of PEH units should be carefully chosen, since the units embedded in an optimal position can harvest three times more than that embedded in other positions. The concise criteria presented in this study will be used as a reference not only for material selection, dimension optimization, and embedded positions determination of PEH units but also for choosing of the optimal roadways to achieve maximum piezoelectric energy harvesting efficiency under open-traffic conditions.

A Pavement Piezoelectric Energy Harvester for Small Input Displacements

The Optimal Design of a Piezoelectric Energy Harvester for Smart Pavements

A piezoelectric human motion energy harvester with stress amplification mechanism

Mechanical Energy Harvesting from Road Pavements under Vehicular Load Using Embedded Piezoelectric Elements

The Analysis and Design of a High Efficiency Piezoelectric Harvesting Floor with Impacting Force Mechanism

Piezoelectric Energy Harvesting From Roadways Based on Pavement Compatible Package

Scavenging energy from human walking through a shoe-mounted piezoelectric harvester

Piezoelectric Energy Harvesting from Roadways under Open-Traffic Conditions: Analysis and Optimization with Scaling Law Method

Theoretical Assessment on Piezoelectric Energy Harvesting in Smart Self-powered Asphalt Pavements

Development of a Pavement-Embedded Piezoelectric Harvester in a Real Traffic Environment

Experimental Investigation of Piezoelectric Energy Harvesters Applied in Concrete Pavement

Performance Assessment and Comparison of Two Piezoelectric Energy Harvesters Developed for Pavement Application: Case Study

An enhanced broadband piezoelectric energy harvester via elastic amplification structure for multidirectional vibration

An inclined pedal type piezoelectric energy harvester for pedestrian flow and vehicle safety monitoring

Multimodal Multidirectional Piezoelectric Vibration Energy Harvester by U-Shaped Structure with Cross-Connected Beams

Development and performance of a piezoelectric energy conversion structure applied in pavement

A Piezoelectric Energy Harvester for Human Body Motion Subjected to Two Different Transversal Reciprocating Excitations

Design and Comparative Study of a Small-Stroke Energy Harvesting Floor Based on a Multi-Layer Piezoelectric Beam Structure

Piezoelectric Hinged Beam with Arc Mass Stopper for Vibration and Human Motion Energy Harvesting

Performance Analysis of Piezoelectric Energy Harvesting in Pavement: Laboratory Testing and Field Simulation

Low-Cost Novel Piezoelectric Module for Harvesting Energy from Two-Layer Pavement Systems