Photoelectrochemical CO 2 reduction in Tandem Photoelectrode Cells: Interpretation of Apparent Photocurrents

Michele Del Moro,Radu-George Ciocarlan,Beatriz De la Fuente,Daniel Choukroun,Pegie Cool,Annick Hubin,Tom Hauffman,Tom Breugelmans
DOI: https://doi.org/10.1016/j.electacta.2024.144493
IF: 6.6
2024-05-28
Electrochimica Acta
Abstract:Photoelectrochemical reactors harness solar energy to accelerate heterogeneous chemical reactions and reduce power consumption for a given reaction rate. The tandem photoelectrochemical cell design presented here employs a light penetrable TiO 2 photoanode||Cu 2 O photocathode configuration that enables carbon dioxide turnover at limited cell voltages. During polarization tests, the tandem configuration demonstrated a photocurrent density of 0.2 mA/cm 2 at a cell voltage of -2.6 V. That is 2-fold higher than the photocurrent density obtained with a solo photoanode (Cu||TiO 2 ) and five orders of magnitude higher compared to the solo photocathode (Cu 2 O||Ni) design. Moreover, electrolysis under illumination (photoelectrolysis) showed a current density increase of 3.9 mA/cm 2 with respect to electrolysis in the dark. However, this photocurrent density was merely apparent and was caused by light-triggered changes in the surface morphology and phase of Cu 2 O, which in turn affected the catalytic response. Moreover, the apparent partial ethylene photocurrent density and total partial current density during photoelectrolysis was 44%, the highest among the detected products. That selectivity is attributed to the combined effect of Cu 2 O photoreduction and the associated local pH rise at the electrode-electrolyte interface.
electrochemistry
What problem does this paper attempt to address?