Abstract:The enhancement in selectivity of nanofiltration (NF) membranes is of great significance for extending the application areas and improving the process economy, especially for the separation of monovalent/divalent ions. The characteristics of moderately increased pore size, fewer nonselective defects and a more uniform structure are conducive to NF membrane exhibiting higher rejection of divalent ions but lower rejection of monovalent ions. Nonylphenol polyoxyethylene ether (NP-10) was introduced in interfacial polymerization process in this study to optimize the microstructure and surface properties of polyamide (PA) layer to manufacture highly selective NF membranes. The hydrophobic benzene ring and aliphatic chain in NP-10 could form a local space that restricted the interfacial polymerization reaction on the side of the oil phase, thereby appropriately increasing the pore size of the PA layer. It was advantageous to the permeation of water molecules and monovalent ions with a smaller radius. The long hydrophilic oxyethylene group as a guide could facilitate the uniform diffusion of the monomer to the water/hexane interface. NP-10 as an amphiphilic substance would form a self-assembled network at the water/hexane interface, which was expected to optimize the distribution of aqueous amine monomers at the phase interface. Meanwhile, introducing NP-10 can form a stable interface and reduce the interface disturbance, thus inhibiting the formation of non-selective macropores (or “defects”) in PA layer, which could improve the separation selectivity of monovalent/divalent ions. In addition, the hydrophilicity and electronegativity were also enhanced. The results showed that the MWCO of NF membrane increased from 210.1 Da (TFC-0) to 269.6 Da (TFC-0.25), and the average pore radius increased from 0.248 nm to 0.276 nm. The water flux of optimized membrane was doubled compared to the control membrane. Most important, the optimized exhibited higher rejection of divalent Na2SO4 (from 98.07% to 99.43%), and meanwhile lower rejection of monovalent NaCl (from 54.07% to 27.52%). NaCl/Na2SO4 separation factor reached up to 130.53, which was about four times of TFC-0 membrane.

Incorporations of 2,2′‐benzidinedisulfonic acid and forward osmotic extraction‐favored nanoparticles in polyethersulfone nanofiltration membrane for the simultaneous enhancements in nitrate rejection and water permeation

Novel composite nanofiltration membranes containing zwitterions with high permeate flux and improved anti-fouling performance

Membranes with Negatively-Charged Nanochannels Fabricated from Aqueous Sulfonated Polysulfone Nanoparticles for Enhancing the Rejection of Divalent Anions

High flux positively charged nanofiltration membranes prepared by UV-initiated graft polymerization of methacrylatoethyl trimethyl ammonium chloride (DMC) onto polysulfone membranes

Nitrate rejection of sulfonic acid group incorporated polyethersulfone‐type nanofiltration membrane and reutilization of the concentrated solution

Preparation of Hybrid Nanofiltration Membranes Based on Schiff Base Reaction for Hard Water Softening

Nanofiltration membranes with enhanced performance by constructing an interlayer integrated with dextran nanoparticles and polyethyleneimine coating

Nanocomposite Membranes of Polydopamine/electropositive Nanoparticles/polyethyleneimine for Nanofiltration

Enhancing the desalination performance of polyamide nanofiltration membranes via in-situ incorporation of zwitterionic nanohydrogel

Positively Charged Polysulfonamide Nanocomposite Membranes Incorporating Hydrophilic Triazine-Structured COFs for Highly Efficient Nanofiltration

Fabrication of polyethersulfone/sulfonated polysulfone loose nanofiltration membranes for enhanced selectivity of pharmaceuticals and personal care products and minerals

Fabrication of high performance nanofiltration membranes based on the interfacial polymerization regulated by the incorporation of dextran nanoparticles

Preparation of highly selective nanofiltration membranes by moderately increasing pore size and optimizing microstructure of polyamide layer

Synthesizing high performance robust PSf loose nanofiltration membranes through nanobubble-assisted pore-forming

In-situ incorporating zwitterionic nanocellulose into polyamide nanofiltration membrane towards excellent perm-selectivity and antifouling performances

A Chlorine-Tolerant Nanofiltration Membrane Prepared by the Mixed Diamine Monomers of Pip and Bhttm

Polyhydroxy Group Functionalized Zwitterion for a Polyamide Nanofiltration Membrane with High Water Permeation and Antifouling Performance

A Novel Composite Nanofiltration Membrane Prepared by Interfacial Polymerization of 2,2′-Bis(1-hydroxyl-1-trifluoromethyl-2,2,2-trifluoroethyl)-4,4′-methylenedianiline and Trimesoyl Chloride

Enhancing nanofiltration membrane selectivity between mineral salts and organic pollutants by sulfonic acid functionalization for drinking water treatment

Modulating interfacial polymerization via 1-methylimidazole as reactive additive for nanofiltration membrane with high-performance

Preparation of high-performance nanofiltration membranes with quaternized cross-linked microgels as intermediate layer