Simulation and experimental analysis of fixed and rotating blades on the runner of Oryon Watermill applicable for head drops of the canal

Raj Kumar Chaulagain,Akash Kalwar,Purushottam Khatiwada

DOI: https://doi.org/10.1177/16878132241290115

IF: 2.1

2024-10-29

Advances in Mechanical Engineering

Abstract:Advances in Mechanical Engineering, Volume 16, Issue 10, October 2024. Numerous sites for watermills exist in the world with shallow heads and are possible for power generation either mechanical or electrical. The prime mover required for the energy generation from such sites is in the developing phase with efficient, minimum components, and low cost as a modular unit. The Oryon Watermill (OWM) is one of them developed by Deepwater Energy applicable to water current directly. The working of OWM is used differently on the head drop of the canal with fixed and rotating blades using the NACA 6516 series of airfoil shapes as the novelty of this research. The research covers the CFD simulations with ANSYS Fluent 19.0 of two runners, fabrication, and conduction of tests on-site with a head drop of 1.2 m. The major variable was the water flow rate for both runners with the design discharge of 0.09 m3/s. The analysis of results showed the runner with rotating lamellas performed with 9% and 40% higher efficiency from the simulation and experiment respectively compared to the fixed type. The efficiency achieved from the research is at a low range indicating the availability of large space for future study on performance improvement.

engineering, mechanical,thermodynamics