Decreasing the cutting height increases young and mature switchgrass yield with no impact on quality and stand vigor at different harvesting seasons

Sowmya Koduru,Leryn Gorlitsky,Masoud Hashemi,Stephen J. Herbert,Amir Sadeghpour
DOI: https://doi.org/10.1016/j.biombioe.2024.107153
IF: 5.774
2024-03-16
Biomass and Bioenergy
Abstract:Harvest management practices significantly impact high-quality switchgrass ( Panicum virgatum L.) production for combustion. A three-year study at the University of Massachusetts and a Conservation Research Program (CRP) explored the interactive effects of season of harvest (summer, fall, and spring) and cutting height (7.5 vs. 15 cm) on biomass yield, mineral content, and non-structural carbohydrate (NSC) reserves of young (2-yr old) and mature (10-yr old) switchgrass (cv. Cave-in-Rock) stands. Results indicated that delaying harvest from summer to spring led to a 25% decrease in biomass yield in young stands, while mature stands exhibited consistent biomass regardless of the season of harvest. Lowering the cutting height from 15 cm to 7.5 cm increased biomass yield by 19% in the young stands and 22% in the mature stands, offering a promising strategy for optimizing yield. Ash and mineral nutrient concentrations decreased over the study years, with variations observed among harvest seasons. Among NSCs, water-soluble sucrose (WSuc) and total sugars (WTS) increased with each passing year in both young and mature stands. Harvesting in fall resulted in the highest NSC concentration indicating maximum vigor for regrowth over years. Cutting height alone did not have a significant influence on ash and mineral content. The study suggests that reducing cutting height to 7.5 cm maximizes profit without compromising quality or stand vigor. Therefore, we recommend combining a cutting height of 7.5 cm with a fall harvest to maximize switchgrass production, with high quality and NSCs concentrations for increasing farm profit and maintaining switchgrass vigor over time.
energy & fuels,biotechnology & applied microbiology,agricultural engineering
What problem does this paper attempt to address?