Direct atomic layer deposition of ultrathin aluminium oxide on monolayer $MoS_2$ exfoliated on gold: the role of the substrate

Emanuela Schilirò,Raffaella Lo Nigro,Salvatore E. Panasci,Simonpietro Agnello,Marco Cannas,Franco M. Gelardi,Fabrizio Roccaforte,Filippo Giannazzo
DOI: https://doi.org/10.48550/arXiv.2108.09542
2021-08-21
Applied Physics
Abstract:In this paper we demonstrated the thermal Atomic Layer Deposition (ALD) growth at 250 {\deg}C of highly homogeneous and ultra-thin ($\approx$ 3.6 nm) $Al_2O_3$ films with excellent insulating properties directly onto a monolayer (1L) $MoS_2$ membrane exfoliated on gold. Differently than in the case of 1L $MoS_2$ supported by a common insulating substrate ($Al_2O_3/Si$), a better nucleation process of the high-k film was observed on the 1L $MoS_2/Au$ system since the ALD early stages. Atomic force microscopy analyses showed a $\approx 50\%$ $Al_2O_3$ surface coverage just after 10 ALD cycles, its increasing up to $>90\%$ (after 40 cycles), and an uniform $\approx$ 3.6 nm film, after 80 cycles. The coverage percentage was found to be significantly reduced in the case of 2L $MoS_2/Au$, indicating a crucial role of the interfacial interaction between the aluminum precursor and $MoS_2/Au$ surface. Finally, Raman spectroscopy and PL analyses provided an insight about the role played by the tensile strain and p-type doping of 1L $MoS_2$ induced by the gold substrate on the enhanced high-k nucleation of $Al_2O_3$ thin films. The presently shown high quality ALD growth of high-k $Al_2O_3$ dielectrics on large area 1L $MoS_2$ induced by the Au underlayer can be considered of wide interest for potential device applications based on this material system.
What problem does this paper attempt to address?