Pilot clinical study to evaluate the efficacy of a professionally delivered high fluoride varnish on erosive tooth wear in an in-situ model

David W. Bartlett,Sagar P. Jadeja,Rupert S. Austin,Bernal Stewart,Qichao Ruan,Betty Won,Nihal Dogu,Mark Vandeven,Stacey Lavender
DOI: https://doi.org/10.1016/j.jdent.2024.104884
IF: 4.991
2024-02-20
Journal of Dentistry
Abstract:KHN Objectives The aim for this pilot study was to investigate the effect of a sodium fluoride varnish on step height measured by a profilometer from human enamel worn by healthy volunteers with a novel in situ/ex vivo erosion design. Method Healthy volunteers aged 18-70 years wore a palatal splint containing 8 human enamel samples and underwent two 3-day treatment periods for 6 hours a day with a varnish containing sodium fluoride at 22,600 ppm and the control with the same ingredients but without fluoride. Each splint contained 4 polished and 4 unpolished samples. The interventions were applied to the surface of the enamel samples in randomised order, removed after 6 hours, then immersed ex-vivo in 1 %, pH 2.7 citric acid for 2 minutes, repeated 4 times a day, over 2 days. Measurements of enamel were assessed blindly by microhardness on day 2 and by non-contact laser profilometry on day 3 for the two treatments. Results 24 volunteers, 2 males and 22 females aged 27 - 54 years, were screened and recruited. The delta microhardness, from polished samples removed at the end of day 2, for the control and fluoride treatment was 95.7 (22.9) kgf/mm 2 and 123.7 (28.9) kgf/mm 2 , respectively (p < 0.005). The mean (SD) step height for the control polished enamel surfaces was 3.67 (2.07) μm and for the fluoride varnish was 1.79 (1.01) μm (p < .0005). The control unpolished enamel surfaces had a mean 2.09 (1.53) μm and the fluoride varnish was 2.11 (1.53) μm but no statistical difference was detected. Conclusions The results from this pilot study, utilizing an in-situ model where enamel was exposed to acid over the course of 2 days, demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm prevented erosive wear compared to a control on the polished enamel surfaces. Clinical significance Intra-oral study demonstrated that a high fluoride varnish containing sodium fluoride at 22,600 ppm reduced erosive tooth wear.
dentistry, oral surgery & medicine
What problem does this paper attempt to address?