Abstract:Battery thermal management systems play a significant role in the safety, performance, and maintenance of electric vehicles. This paper proposes a new hybrid cooling system incorporated with phase change material (PCM) and liquid cooling to achieve high performance and safety for the pack of prismatic batteries. Each four battery cells are grouped as a module and placed between vertically orientated mini-channel cold plates. PCM plates are also placed horizontally between the battery cells. This new design is simple enough to be implemented easily in common cooling systems and could provide parallel cooling of the active and passive methods with subsequent improvement in thermal performance and system safety. Three-dimensional numerical simulations are validated against previous empirical and numerical works. The thermal performance, power consumption, and safety of the hybrid cooling systems are investigated in a variety of battery discharge rates and mini-channel inlet velocities using different numbers of PCM plates. Also, the system performance is tested in a real driving cycle. This new design could notably improve the battery thermal management characteristics. The maximum battery temperatures in the hybrid system with three PCM plates at 2C and 3C discharge rates were 5.6 K and 16.2 K lower than those without PCM plates. Besides, adding three PCM plates reduced the temperature difference by up to 33 % at 3C discharge rate. Another key finding was that at 3C discharge rate, by simultaneously utilizing three PCM plates and decreasing the fluid inlet velocity, the power consumption per battery cell is reduced by 68 % (from 1.187 mW to 0.0375 mW). Furthermore, considering the PCM plates as the emergency backup, the time to reach the critical temperature increased by 38 % and 105 % in the systems with 1 and 3 PCM plates, respectively. Testing in a real driving cycle reveals the superiority of the hybrid system over the active cooling method by peak shaving of the thermal loads and reducing thermal fluctuations and maximum temperature. This novel design for battery thermal management could provide high performance for batteries and reduce fabrication and maintenance costs.

Experimental and numerical analysis of a hybrid cooling concept for an electric battery module

Experimental and Numerical Study of PCM Thermophysical Parameters on Lithium-Ion Battery Thermal Management

Electrochemical–Thermal Evaluation of an Integrated Thermal Management System for Lithium‐Ion Battery Modules

Experimental and Numerical Analysis of a Hybrid Thermal Management Concept at Different Discharge Rates for a Cylindrical Li-Ion Battery Module

Investigation of thermal properties of phase change materials for novel hybrid thermal management strategies for cylindrical Li-ion cells

Investigation of Heat Transfer Enhancement Techniques on a Scalable Novel Hybrid Thermal Management Strategy for Lithium-Ion Battery Packs

A parametric study of a hybrid battery thermal management system that couples PCM/copper foam composite with helical liquid channel cooling

Experimental studies and comprehensive computational investigations on composites-based phase change material for battery thermal management systems in electric vehicles

Numerical study on hybrid battery thermal management system integrating water, phase change material, and fins, under New European Driving Cycle

Enhancing Thermal Performance and Cooling Solutions of Phase Change Material in Battery Thermal Management System: A Computational Analysis

Thermal management of lithium-ion battery module using the phase change material

Numerical Investigation of the Thermal Performance of a Hybrid Phase Change Material and Forced Air Cooling System for a Three-Cell Lithium-Ion Battery Module

Parameter optimization and sensitivity analysis of a Lithium-ion battery thermal management system integrated with composite phase change material

Numerical analysis of different fin structures in phase change material module for battery thermal management system and its optimization

A numerical study on a hybrid battery thermal management system based on PCM and wavy microchannel liquid cooling

Numerical investigation on integrated thermal management for a lithium-ion battery module with a composite phase change material and liquid cooling

Numerical analysis of lithium-ion battery thermal management system using phase change material assisted by liquid cooling method

Hybrid battery thermal management by coupling fin intensified phase change material with air cooling

Experimental and Numerical Study on a Novel Hybrid Battery Thermal Management System Integrated Forced-Air Convection and Phase Change Material

An improved hybrid thermal management system for prismatic Li-ion batteries integrated with mini-channel and phase change materials

A hybrid battery thermal management system using ionic wind and phase change material