Abstract:The effects of Ca(II), Mg(II), Cu(II), and Fe(III) on the flotation separation of spodumene from feldspar and quartz were investigated by single-mineral and artificial-mixed-ore flotation experiments using α-bromododecanoic acid (α-BDDA) as a collector. At pH≈7, Ca(II), Mg(II), and Cu(II) selectively improved the flotation of spodumene, which facilitated the separation of spodumene. Although Fe(III) exhibited strong activation ability, its selectivity toward spodumene was low, which impaired the separation of spodumene. Moreover, the sequence of addition of metal ions had an impact on the separation of spodumene. When Ca(II) and Mg(II) were used as activators in the artificial-mixed-ore flotation experiments, concentrates with recoveries of 75.6% and 76.3% and Li2O grades of 5.8% and 5.2% were obtained, respectively. Adsorption and activation mechanisms of metal ions were analyzed by adsorption amount measurements, Fourier transform infrared spectroscopy, species distribution calculation, and frontier orbital theory calculation. Results indicated that the amount of α-BDDA adsorbed on spodumene was higher than those adsorbed on feldspar and quartz when Ca(II), Mg(II), and Cu(II) were employed as activators, which led to a higher recovery of spodumene. When the pH was approximately 7, Ca(II), Mg(II), Fe(III), and Cu(II) were mainly present as Ca2+, Mg2+, Fe(OH)3 and Fe(OH)2+, and Cu(OH)2, Cu2+, and Cu(OH)+, respectively. The results of frontier orbital theory calculations demonstrated that α-BBBA, Ca2+, and Mg2+ easily adsorbed on spodumene than on feldspar and quartz. Therefore, Ca(II) and Mg(II) facilitated the separation of spodumene. However, Fe(OH)2+ preferentially reacted with spodumene, whereas Fe(OH)3 preferably reacted with feldspar and quartz, which caused low selectivity of Fe(III) toward spodumene. Similarly, Cu2+ and Cu(OH)+ easily adsorbed on spodumene, whereas Cu(OH)2 preferentially adsorbed on feldspar and quartz. Thus, the selectivity of Cu(II) toward spodumene was inferior compared to those of Ca(II) and Mg(II).

Effect of aluminum ion on rutile flotation

Depression Effect of Al(Ⅲ) and Fe(Ⅲ) on Rutile Flotation Using Dodecylamine Polyxyethylene Ether As Collector

Original Data and Descriptions from Inhibition Mechanism of Ca2+, Mg2+ and Fe3+ in Fine Cassiterite Flotation Using Octanohydroxamic Acid

Effects of Alkyl Ether Amine and Calcium Ions on Fine Quartz Flotation and Its Guidance for Upgrading Vanadium from Stone Coal

Novel insights into the microstructure of Al-BHA on the surface of ilmenite

Behavior of Lead Ions in Cassiterite Flotation Using Octanohydroxamic Acid

Flotation Separation of Rutile from Almandine Using Octadecyl Amine Polyoxyethylene Ether As Collector

Inhibition Mechanism of Ca2+, Mg2+ and Fe3+ in Fine Cassiterite Flotation Using Octanohydroxamic Acid

The Effect of Aluminum Ions on the Flotation Separation of Pentlandite from Lizardite

Efficient Flotation Separation of Ilmenite and Olivine in a Weak Alkaline Pulp Using a Ternary Combination Collector Centered around Al3+

The flotation behaviour of N-(3-aminopropyl)-dodecanamide on three aluminosilicates

Effect of metal ions on the flotation separation of biotite from quartz using mixed anionic/cationic collectors

Flotation Separating Rutile from Calcium and Silicon Gangue Minerals

Effect of aluminum speciation on arsenic removal during coagulation process

Effects of metal ions on the flotation separation of spodumene from feldspar and quartz

Effect of different particle size fractions on flotation separation of fine rutile from garnet

Application and Mechanism of Mixed Anionic/Cationic Collectors on Reverse Flotation of Hematite

Behavior and Mechanism of Sodium Sulfite Depression of Almandine from Rutile in Flotation System

Effects of Fluoride on Coagulation Performance of Aluminum Chloride Towards Kaolin Suspension

Aluminum Affects Heterogeneous Fe(III) (hydr)oxide Nucleation, Growth, and Ostwald Ripening.

Effects of surface Chemistry, particle morphology and pretreatment on zircon flotation