Abstract:A computational scheme was used to screen physical solvents for CO2 pre-combustion capture by integrating the commercial NIST database, an in-house computational database, chem-informatics, and molecular modeling. A commercially available screened hydrophobic solvent, diethyl sebacate, was identified from the screening with favorable physical properties and promising absorption performance. The promising performance to use diethyl sebacate in CO2 pre-combustion capture has also been confirmed from experiments. Water loading in diethyl sebacate is very low, and therefore, water is kept with H2 in the gas stream. The favorable CO2 interaction with diethyl sebacate and the intermediate solvent free volume fraction leads to both high CO2 solubility and high CO2/H2 solubility selectivity in diethyl sebacate. An in-house NETL computational database was built to characterize CO2, H2, N2, and H2O interactions with 202 different chemical functional groups. It was found that 13% of the functional groups belong to the strong interaction category with the CO2 interaction energy between -15 and -21 kJ/mol; 62% of the functional groups interact intermediately with CO2 (-8 to -15 kJ/mol). The remaining 25% of functional groups interact weakly with CO2 (below -8 kJ/mol). In addition, calculations show that CO2 interactions with the functional groups are stronger than N2 and H2 interactions but are weaker than H2O interactions. The CO2 and H2O interactions with the same functional groups exhibit a very strong linear positive correlation coefficient of 0.92. The relationship between CO2 and H2 gas solubilities and solvent fractional free volume (FFV) has been systematically studied for seven solvents at 298.2 K. A skewed bell-shaped relation was obtained between CO2 solubility and solvent FFV. When an organic compound has a density approximately 10% lower than its density at 298.2 K and 1 bar, it exhibits the highest CO2 loading at that specific solvent density and FFV. Note that the solvent densities were varied using simulations, which are difficult to be obtained from the experiment. In contrast, H2 solubility results exhibit an almost perfect positive linear correlation with the solvent FFV. The theoretical maximum and minimum physical CO2 solubilities in any organic compound at 298.2 K were estimated to be 11 and 0.4 mol/MPa L, respectively. An examination of 182 experimental CO2 physical solubility data and 29 simulated CO2 physical solubilities shows that all the CO2 physical solubility data are within the maximum and minimum with only a few exceptions. Finally, simulations suggest that in order to develop physical solvents with both high CO2 solubility and high CO2/H2 solubility selectivity, the solvents should contain functional groups which are available to interact strongly with CO2 while minimizing FFV.

In Silico Screening of CO2‐Dipeptide Interactions for Bioinspired Carbon Capture

Unveiling the Porosity Effect of Superbase Ionic Liquid-Modified Carbon Sorbents in CO 2 Capture from Air

Direct air capture multiscale modelling: From capture material optimization to process simulations

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Computational Screening of Physical Solvents for CO2 Pre-combustion Capture

Computational Study of Carbon Dioxide Capture by Tertiary Amines

CO2 Capture in Ionic Liquids Based on Amino Acid Anions With Protic Side Chains: a Computational Assessment of Kinetically Efficient Reaction Mechanisms

A general Energy-Efficient strategy for optimizing CO 2 Capture: Designing and harnessing the rapid adsorption kinetics of Amine-Impregnated adsorbents

Atom-level interaction design between amines and support for achieving efficient and stable CO2 capture

Unraveling the mechanism and the role of hydrogen bonds in CO 2 capture by diluent-free amine sorbents through a combination of experimental and theoretical methods

Computational Study on CO2 Absorption Mechanism and Structure–activity Relationship of Biphasic Solvent

Design of Amine-Functionalized Materials for Direct Air Capture Using Integrated High-Throughput Calculations and Machine Learning

Investigation of Rational Design of Amine Solvents for CO2 Capture: A Computational Approach

Charting the chemical space of modular heterocyclic nucleophiles for CO₂ capture

Direct Air Capture of CO2 Using Poly(ethyleneimine)-Functionalized Expanded Poly(tetrafluoroethylene)/Silica Composite Structured Sorbents

CO2 Capture in Biocompatible Amino Acid Ionic Liquids: Exploring the Reaction Mechanisms for Bimolecular Absorption Processes

Tetrameric self-assembling of water-lean solvents enables carbamate anhydride-based CO2 capture chemistry

Multi-Criteria Screening of Organic Ethanolamines for Efficient CO2 Capture Based on Group Contribution Method

Discovering Inherent Characteristics of Polyethylenimine-Functionalized Porous Materials for CO2 Capture

Identifying Promising Covalent-Organic Frameworks for Decarburization and Desulfurization from Biogas via Computational Screening

The Carbon Challenge: Design, Synthesis, and Chemisorption Behavior of Solid Sorbents in Direct Air Capture of Carbon Dioxide