Abstract:Direct membrane filtration (DMF) has gained a lot of attention in recent years because of its potential to treat low-strength and low temperature wastewater, where biological based treatments are inefficient. However, fouling is a major concern which keeps this technique from being more widely used. The main aim of this study was to investigate membrane fouling, its mitigation approaches and the organic/nutrient retention during DMF of municipal wastewater by adjusting operational parameters and pretreating the sewage. In a laboratory-scale setup employing crossflow to mitigate fouling, both ultrafiltration and microfiltration membranes were utilized. Physicochemical pre-treatment of sewage with polyaluminum chloride and polyamide significantly inhibited membrane fouling and improved organics/nutrient retention. Subsequent experiments with physiochemically pre-treated sewage, using microfiltration and ultrafiltration separately, revealed that (i) an increase in crossflow velocity from 1 to 2 m s −1 improved filtration performance by reducing irreversible fouling, (ii) elevating transmembrane pressure from 0.18 to 0.4 bar increased both reversible and irreversible fouling, and (iii) periodic relaxation increased the extent of irreversible fouling, contributing to higher overall fouling in ultrafiltration. When employing DMF for sewage concentration, ultrafiltration demonstrated superior filtration performance and organics retention compared to microfiltration. Furthermore, through pre-precipitation and microsieving (100 μm) followed by DMF with ultrafiltration membranes, a remarkable removal efficiency of 92 % for chemical oxygen demand (COD), 98 % for total phosphorus (TP), and 100 % for total suspended solids (TSS) was achieved. By cleaning the fouled membranes using an alkaline cleaning solution (Ultrasil-10) at 50 °C, combined with a crossflow of 1 m s −1 , the permeability was completely restored. Overall, this study demonstrates that by optimizing operational settings and cleaning conditions, a sustainable DMF process for wastewater treatment with controlled membrane fouling and improved resource recovery can potentially be developed for upscaling. Short abstract This study investigated the effectiveness of direct membrane filtration for municipal wastewater treatment. It was found that physicochemical pre-treatment with polyaluminum chloride and polyamide significantly reduced membrane fouling and improved nutrient retention. Ultrafiltration membranes demonstrated superior performance and nutrient retention compared to microfiltration membranes. By optimizing operational parameters and cleaning conditions, a sustainable direct membrane filtration process with controlled fouling and improved resource recovery can be developed for wastewater treatment.

Pre-filtration for enhancing direct membrane filtration of graywater from washing machine discharges

Direct Membrane Filtration (DMF) of municipal wastewater – A study on the prevention and remediation of fouling

Low strength graywater characterization and treatmentby direct membrane filtration

Investigation Of Microfiltration For Pretreatment Of Whey Concentration

Direct membrane filtration of municipal wastewater: Assessment of different fouling control strategies to enhance its energy, environmental and economic viability

Coupling Ferrate Pretreatment and In-Situ Ozonation/ceramic Membrane Filtration for Wastewater Reclamation: Water Quality and Membrane Fouling

Membrane filtration technologies applied to municipal secondary effluents for potential reuse

Coupling Continuous Sand Filtration to Ultrafiltration for Drinking Water Treatment: Improved Performance and Membrane Fouling Control

Characterization and Mitigation of the Fouling of Flat-Sheet Ceramic Membranes for Direct Filtration of the Coagulated Domestic Wastewater

Reducing Ultrafiltration Membrane Fouling During Potable Water Reuse Using Pre-Ozonation.

Direct Membrane Filtration of Municipal Wastewater: Studying the Most Suitable Conditions for Minimizing Fouling Rate in Commercial Porous Membranes at Demonstration Scale

Membrane fouling control and contaminant removal during direct nanofiltration of surface water

Hybrid UF/NF Process Treating Secondary Effluent of Wastewater Treatment Plants for Potable Water Reuse: Adsorption Vs. Coagulation for Removal Improvements and Membrane Fouling Alleviation.

Fouling and Mitigation Mechanisms During Direct Microfiltration and Ultrafiltration of Primary Wastewater

Reduced Low–Pressure Membrane Fouling by Inline Coagulation Pretreatment for a Colored River Water

Improvement of crossflow microfiltration performances for treatment of phosphorus-containing wastewater

Ferrate Preoxidation Alleviating Membrane Fouling Through the Formation of a Hydrophilic Prefiltration Layer

The Use of Microfiltration for the Pretreatment of Backwash Water from Sand Filters

Biological Pre-Treatments Enhance Gravity-Driven Membrane Filtration for the Decentralized Water Supply: Linking Extracellular Polymeric Substances Formation to Flux Stabilization

Effects of Pre-Treatments on the Filtration Performance of Ultra-Low Pressure Gravity-Driven Membrane in Treating the Secondary Effluent: Flux Stabilization and Removal Improvement

Study on Cleaning of Microfiltration Membrane for Advanced Treatment of Tap Water