Abstract:To address the problems of the conventional composite supporting structures (CCSSs) such as insufficient anti-dislocation performance and deformation capacity, this study used Engineered Cementitious Composite (ECC) lining sections instead of the traditional lining sections and optimized support design parameters, resulting in the development of novel ECC-RC composite supporting structures (ECSSs) of tunnels passing through active fault. The dislocation response characteristics and their parameter sensitivity of the ECSS was revealed by way of 1/25-scale fault dislocation model tests and finite element analysis. The test results show that the mechanical response characteristics and the failure modes of the CCSS and the ECSS are similar under reverse fault dislocation. Compared with the CCSS, the anti-dislocation performance of the ECSS is significantly improved by introducing of the ECC lining and optimizing the design parameters. The vertical deformation of the ECSS and the range of influence under the same dislocation are significantly decreased, and the strain are reduced to different degrees. This phenomenon shows that by improving the material properties, shortening the spacing of aseismatic joints and optimising the thickness of the shock absorption layer, the stress conditions and applicability under deformation of the structure are improved. The ECSS benefits from the crack resistance and toughening effect of fibres, the degree and scope of cracking of the ECSS are significantly reduced compared with those of the CCSS, and internal and external through cracks and local spalling are absent. The results of finite element analysis show that the overall damage degree of the ECSS is decreased and the damage range is increased by decreasing the strength of the surrounding rock in the fault zone. The fault dislocation response pattern of the ECSS varies depending on the fault type. The damage degree caused by different fault types follows the order of normal fault, strike-slip fault, and reverse fault from large to small. However, the damage range caused by the strike-slip fault is significantly larger compared to normal fault and reverse fault. In the design of fault resistance, the surrounding rock conditions of the fault zone and the form of fault dislocation should be considered.

Performance of Engineered Cementitious Composites (ECC) in shield tunnel segmental joints: A comparative study with ordinary reinforced concrete

Full-scale Experimental and Structural Characterization Study of Shield Tunnel Reinforcement under Ground Stacking Loads

Experiments and Numerical Simulation of the Reinforcement Effect of Channel-Steel-reinforced Shield Tunnel Segments under Unloading Conditions

Bond Behavior and Failure Mechanisms of the Interface between Engineered Cementitious Composites and Shaped Steel

Numerical Analysis of the Seismic Response of Tunnel Composite Lining Structures across an Active Fault

Numerical study on mechanical behavior and ultimate bearing capacity of shield segment joints under different load conditions

Full-scale Loading Test for Shield Tunnel Segments: Load-bearing Performance and Failure Patterns of Lining Structures

Mechanical‐performance deterioration of RC segment of shield tunnel under high corrosion degree and the transformation of eccentric‐failure mode

Cyclic behavior of joints assembled using prefabricated beams and columns with Engineered Cementitious Composite (ECC)

Dislocation response of ECC-RC composite supporting structures of tunnels passing through active fault

Performance of engineered cementitious composite (ECC) monolithic and composite slabs subjected to near-field blast

Thickness Effect of Engineered Cementitious Composites Subjected to Quasi-Static and Dynamic Tension

Numerical analysis of tunnel segments strengthened by steel–concrete composites

Experimental study on the mechanical behavior of segmental joints of shield tunnels strengthened by a steel plate-UHPC composite

Experimental study on the axial compressive behaviour of steel reinforced concrete composite columns with stay-in-place ECC jacket

Seismic Performance of a Novel Precast Beam-Column Joint Using Shape Memory Alloy Fibers-Reinforced Engineered Cementitious Composites

Flexural Performance of UHPC–Concrete–ECC Composite Member Reinforced with Perforated Steel Plates

Prefabricated UHPC-concrete-ECC underground utility tunnel reinforced by perforated steel plate: Experimental and numerical investigations

Seismic Behavior of Reinforced Engineered Cementitious Composite Members and Reinforced Concrete/engineered Cementitious Composite Members: A Review

Fresh/Mechanical/Durability Properties and Structural Performance of Enginnered Cementitious Composite (ECC)

Recent studies on the mechanical properties of Engineered Cementitious Composite