Abstract:When manufacturing parts for thermal control systems for operation in especially difficult conditions of the North and in spacecraft, titanium and complex alloyed alloys are used. They are subject to increased quality requirements. They are achieved through simulation modeling. The solution is based on a dynamic model in which the contact interaction between the tool flank and the workpiece is differentiated. The process of contact interaction is considered as two-phase in the form of a sequence of states of adhesion and sliding. In the space of state variables, a system of nonlinear differential equations of piecewise linear type is constructed based on a set of rheological models. Based on this model, simulation modeling was carried out in the form of a computational experiment. A periodic solution is obtained which is formed as a result of switching the sliding and adhesion phases. In the graphs presented in the paper, the transition from the adhesion phase to the sliding phase is accompanied by a surge in displacement. In this case, in the phase portrait, the phase trajectory reaches the limit cycle with a limited amplitude. At the moment of transition from the adhesion phase to the sliding phase, a characteristic deviation of the phase trajectory from the limit cycle with an increased amplitude is observed, followed by a return to the limit cycle. With a wide variation in cutting speed, the conditions for technical stability are determined. During the simulation, a dynamic manifestation of the formation of chip elements was found, which did not have a serious impact on the nature of dynamic processes. The results obtained make it possible to study the dynamics of contact interactions during cutting in the framework of nonlinear dynamic models. This makes it possible to assess the level of vibration amplitudes and determine the regulated parameters of processing accuracy and surface roughness of manufactured products.

Nonlinear dynamics of a regenerative cutting process

Chaotic vibrations in a regenerative cutting process

Multiple Regenerative Effects in Cutting Process and Nonlinear Oscillations

Modelling of Regenerative and Frictional Cutting Dynamics

High-Dimensional Chaotic Dynamics in Cutting Systems with Time-Delay Effects

Regenerative and Frictional Chatter in Plunge Grinding

Statistical Basin of Attraction in Time-Delayed Cutting Dynamics: Modelling and Computation

Bifurcation analysis of thin-walled structures trimming process with state-dependent time delay

Dynamics of Milling Processes with Variable Time Delays

Studying the dynamics of contact interactions during machining based on a system of nonlinear piecewise linear differential equations

Nonlinear Dynamics Stability Analysis of Cutting a Slender Shaft

The nonlinear dynamics analysis of stochastic delay Jeffcott rotor-seal system with the elastic support

Nonlinear stochastic modeling with Langevin regression

Nonlinear chatter with large amplitude in a cylindrical plunge grinding process

Non-linear analysis and quench control of chatter in plunge grinding

Nonlinear Response and Nonsmooth Bifurcations of an Unbalanced Machine-Tool Spindle-Bearing System

Nonlinear Dynamic Analysis of Rotor-Bearing System with Cubic Nonlinearity

Nonlinear Dynamical Behaviors of a Blade-Shaft-Bearing System

Non-Linear Dynamics of an Unbalanced Machine-Tool Spindle System Supported by Ball Bearings

Regenerative Chatter in Self-Interrupted Plunge Grinding

Investigation Of Friction Induced Vibrations On A Nonlinear Two Degree Of Freedom Mathematical Model And Experimental Validation