Abstract:Shear cutting allows for shaping materials with any length of cutting line with high efficiency and without negative thermal effects, but it causes stresses and deformations in the cutting zone of the material. This has a negative effect on the magnetic properties of the sheet in the areas of the cut edge. The main problem on production lines is to ensure appropriate control of the process so as to obtain the appropriate technological quality of the cut edge, free of not only defects in the form of burrs and shape deviations, but also the minimum deformed zone. This task is difficult due to the large number of control variables, the influence of which on the shaping of the material and the formation of the cut edge is not fully understood. The article attempts to determine the course of the cutting process and to examine the influence of control variables on the formation of the cut edge in the shear-slitting process in which the tools perform a rotary motion. For this purpose, FEM modeling, vision techniques and experimental studies were used. A 3D model of the process was developed, which enables a detailed analysis of the states of stresses, strains, displacements and fracture mechanisms of the material. The simulation results were verified using vision techniques, which were used in the work to observe the flow and cracking mechanisms of the material. Parametric analyses were performed for the process control variables. The research showed a significant influence of the cutting velocity and the clearance between the tools on the formation of the cut edge. The most homogeneous surface of the cut edge with the minimum burr height was obtained for the following parameters: rake angle α = 15–30°, horizontal clearance hc = 0.03 mm and slitting velocity v2 = 15 m/min. The developed results can be useful for controlling the cutting process on production lines in terms of maximum process efficiency while maintaining the appropriate technological quality of the cut edge.

Using Nonlinear Contact Mechanics in Process of Tool Edge Movement on Deformable Body to Analysis of Cutting and Sliding Burnishing Processes

Molecular Dynamics Simulation of Elastic–plastic Deformation Associated with Tool–workpiece Contact in Force Sensor–integrated Fast Tool Servo

Study on the Effect of Tool Inclination Angle in Machining Process Based on Three-Dimensional Thermo-Elastic-Plastic Model

Study on Mechanism for Material Removal and Surface Generation by Molecular Dynamics Simulation in Abrasive Processes

Studying the dynamics of contact interactions during machining based on a system of nonlinear piecewise linear differential equations

Finite Element Analysis and Experimental Investigation of Cut Surface Formation of Magnetic Silicon Steel in Shear Cutting

Finite element simulation of cutting process under the worn tool edge geometries

Electrochemical Machining of Curvilinear Surfaces of Revolution: Analysis, Modelling, and Process Control

Dynamic modeling of the turning process of slip-cast fused silica ceramics using the discrete element method

Challenges and issues in continuum modelling of tribology, wear, cutting and other processes involving high-strain rate plastic deformation of metals

Tool-edge geometry effects in semi-to-finish cut machining operations on subsurface integrity and tool thermo-mechanical loadings: A coupled damage-fracture energy based finite element approach

Metrology Influence on the Cutting Modelisation

Cutting force analysis of a linear cutting process of spruce

Modeling and analysis of nonlinear dynamics of machine tool sliding guide

Dynamics Modeling-Based Optimization of Process Parameters in Face Milling of Workpieces with Discontinuous Surfaces

Multiscale characterization and contact performance analysis of machining surfaces

Piecewise approximation and local differential compensation of contact stress distribution of workpiece surface in robotic belt grinding

Multi-physics analytical modeling of the primary shear zone and milling force prediction

Tool degradation effect on roughness factor in the process of physical modeling of cylindrical gear shaving and rolling

Wear modelling in wheel–rail contact problems based on energy dissipation

Experimental and Numerical Investigations and Optimisation of Grain-Oriented Silicon Steel Mechanical Cutting Process