Abstract:The prevalence of concrete-filled steel tubular (CFST) catenary arches, renowned for the optimal load-bearing efficiency, has shown a marked increase over the past decades. To date, extensive research has been conducted into the nonlinear buckling behaviors and elastic-plastic strength of circular and parabolic CFST arches, grounded on the assumption that the curvature of the arch axis remains a specific constant. However, for CFST catenary arches, this assumption is not appropriate, given the substantial variation in curvature along the arch rib, and the influence of the arch axis is not adequately addressed in the existing design codes. Therefore, in this paper, a more precise strain expression is employed to conduct the nonlinear buckling analysis on CFST catenary arches. The analytic solutions for both symmetric snap-through buckling and anti-symmetric bifurcation buckling loads are obtained. In addition, a validated finite element (FE) model is adopted to investigate the influence of key parameters, including the slenderness ratio , the arch-axis coefficient, the rise-to-span ratio, and the steel ratio, on the in-plane stability bearing capacity of CFST catenary arches subjected to axial compression. Moreover, the obtained numerical results are utilized for comparison with the prediction results calculated by the existing design codes for CFST or steel arches. The comparison results indicate that the existing design codes have tended to overestimate the in-plane strength of CFST catenary arches, mainly due to the ignorance of the influence of pre-buckling deformation. Thus, based on the nonlinear buckling analysis results, a revised lower-bound design formula for predicting the in-plane stability bearing capacity of CFST catenary arches under axial compression is proposed, considering the influence of the rise-to-span ratio and the steel ratio.

Experimental Study for Local Buckling of Curved Special-Shaped Pylon

Case Study on Stability Performance of Asymmetric Steel Arch Bridge with Inclined Arch Ribs

Study on Ultra‐low Cycle Fatigue Fracture of Thick‐walled Steel Bridge Piers

Experimental Investigation into Flexural Buckling of Double-Limb Built-Up Plate Members under Compression

Applicability of Effective Tangent Modulus Method in Evaluation of Buckling Strength of Long-Span Cable-Stayed Bridges

Experimental Investigation of Circular Steel Tubes with Tapered Ends Subjected to Bending,compression and Torsion

A unified analysis for distortional and lateral buckling of C-purlins in flexure

Elastic stability of plate simply supported on four sides subjected to combined bending shear and patch loading

BENDING AND TWISTING ABOUT A CONSTRAINED AXIS OF C-SECTION PURLINS WITH ONE SAG ROD AT MIDSPAN

Analysis of Support Abutments of Curved Bridges with Single-pedestal Piers

RESEARCH ON LOCAL BUCKLING OF DODECAGONAL SECTION DOUBLE SKINNED CONCRETE-FILLED STEEL TUBE SHORT COLUMN

Analysis of Ultimate Loading Capacity of the Prestressed Concrete Curved Bridge

In-Plane Failure and Strength of Pin-Ended Circular Steel Arches Considering Coupled Local and Global Buckling

In-plane nonlinear buckling analysis and design method of concrete-filled steel tubular catenary arches

Experimental Investigation of the Overall Buckling Behaviour of 960mpa High Strength Steel Columns

Bearing capacity analysis of a curvilinear box girder landscape bridge

Deformation-based pushover analysis method for transverse seismic assessment of inverted Y-shaped pylons in kilometer-span cable-stayed bridges: Formulation and application to a case study

Torsional behavior of curved concrete box beam with small radius

Curvature response of bridge pier subjected to earthquake action in a saline soil environment

Experimental and Analytical Study on Local Buckling Behavior of High Strength Steel Welded I-Section Beams