BENDING AND TWISTING ABOUT A CONSTRAINED AXIS OF C-SECTION PURLINS WITH ONE SAG ROD AT MIDSPAN

Genshu Tong,Qiang Wu,Lei Zhang

DOI: https://doi.org/10.13204/j.gyjz201312002

2013-01-01

Abstract:The sag rods in purlin systems are regarded as lateral elastic supports .C-section purlins under wind suction were analyzed using the theory of thin-walled members, whose results were compared with those of FE analysis using ANSYS plate elements .It was found that for C-section purlins under wind suction acting through midpoint of upper flange , whose horizontal reaction agreed well with that by ANSYS model , and the reaction in the sag rod was also in good agreement with ANSYS analysis , except on and near the sag rod cross section;on the cross-section of the sag rod, the stresses of the purlin were affected greatly by distorsional deformation caused by sag rod forces .For the controlling compressive stress the EC 3 approach is on the safe side , but for the controlling tensile stresses at the tip of the upper flang lip , distorsional stress should be added to the simple bending stress to achieve acceptable accuracy .