Abstract:With the increasing emphasis on embedding advanced technology into system controls, the Direct Power Control (DPC) approach has garnered considerable attention due to its simple and highly adaptable algorithm. This approach has been increasingly recognized in numerous applications. However, the variable frequency, harmonic distortion of the currents, and power ripples caused by Hysteresis controllers and switching tables decrease its effectiveness and robustness, affecting the system's performance. For this reason, this paper proposed a new DPC based on Artificial Neural Network (ANN) approaches. In this approach, the hysteresis comparator and the switching table are substituted with ANN controllers and then applied on both sides: machine-side converter (MSC) and grid-side converter (GSC) of a Permanent Magnet Synchronous Generator based Wind Energy Conversion System (PMSG-WECS). Moreover, to make the system more efficient in varying wind conditions, this study expands the utilization of the artificial neural networks (ANN) to encompass the maximum power point tracking (MPPT) control strategy. To demonstrate the effectiveness of the proposed approach on the system behaviors, a simulation test was carried out in the Matlab/Simulink environment, using a real wind profile of a Moroccan city (Essaouira). In comparison to the classical DPC control, the simulation results showed the superior performance of the proposed ANN-DPC control in terms of reference tracking, response time, overshoot, precision, and its capacity to reduce the rate of power ripples and total harmonic distortion (THD) in the injected currents. Furthermore, a robustness test was also included in this work to check the robustness of the proposed control against parameters variation. In conclusion, the feasibility and effectiveness of the ANN-DPC control approach were confirmed through experimental validation using the dSPACE DS1104 board.

Design and experimental validation of fault diagnosis and fault tolerant control in PMSG drives for wind energy conversion systems

Finite-time fault detection and reconstruction of permanent magnet synchronous generation wind turbine via sliding mode observer

Sensorless control of permanent magnet synchronous generator in direct-drive wind power system

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

A Sensor-Fault Tolerant Control Method of Active Magnetic Bearing in Flywheel Energy Storage System

Fault Tolerant Control of PMSM Drive Based on Voltage Sensor for Electric Vehicle Application

An Embedded Fault-Tolerant Control Method for Single Open-Switch Faults in Standard PMSM Drives

Enhanced Performance in PMSG-Based Wind Turbine Systems: Experimental Validation of Adaptive Backstepping Control Design

Diagnosis and Tolerance of Common Electrical Faults in T-Type Three-Level Inverters Fed Dual Three-Phase PMSM Drives

Fault Diagnosis in Wind Turbine Current Sensors: Detecting Single and Multiple Faults with the Extended Kalman Filter Bank Approach

Fault Diagnosis Based Machine Learning and Fault Tolerant Control of Multicellular Converter Used in Photovoltaic Water Pumping System

Real‐Time Fault Ride Through Capability Improvement of PMSG‐Wind Turbine Based on Robust Fractional Order Sliding Mode Control

Artificial-Intelligence-Based Open-Circuit Fault Diagnosis in VSI-Fed PMSMs and a Novel Fault Recovery Method

Fault-tolerant Control Strategy of Dual Three-phase PMSG for Wind Turbines

PWM-VSI Fault Diagnosis for a PMSM Drive Based on the Fuzzy Logic Approach

High order sliding mode observer-based fault-tolerant control scheme for DFIG in wind energy applications with model predictive controller

Study on Inverter Fault-Tolerant Operation of PMSM DTC

Fault Detection for PMSM Motor Drive Systems by Monitoring Inverter Input Currents

Design and implementation of energy reshaping based fuzzy logic control for optimal power extraction of PMSG wind energy converter

Fault Diagnosis and Fault Tolerant Control of Wind Turbines: An Overview

Artificial neural network-based direct power control to enhance the performance of a PMSG-wind energy conversion system under real wind speed and parameter uncertainties: An experimental validation