Abstract:The burgeoning demand for enhanced power-system safety means that there is increased attention on technologies for the detection and location of cable faults. The double-terminal fault location method, which senses a fault current using a current transformer (CT), is the most effective and widely applied method in industrial practice. However, CT sensors may suffer from magnetic saturation when exposed to a high fault current, resulting in significant location errors, and their sensitivity cannot be adjusted. To address this problem, this paper describes an improved method for the acquisition of fault signal and the identification of fault-wave arrival time in power cables. First, a novel noncontact sensor (NCS) is developed for the detection of electric fields, and its sensitivity-adjustment curves are obtained by theoretical calculation and simulation. Then, based on feedback variational mode decomposition (FVMD) and the Wigner–Ville distribution (WVD), an improved method (the FVMD + WVD method) for the identification of fault-wave arrival time is devised, and its efficacy and accuracy are verified by simulations in Power Systems Computer-Aided Design/Electromagnetic Transients including DC (PSCAD/EMTDC) software. Finally, the fault-wave arrival-time detection performance of the NCS is examined in a series of on-site DC and AC experiments based on damped AC technology. The results show that the NCS exhibits feasible and effective performance, and that its response can be appropriately tuned based on its sensitivity-adjustment curves. The FVMD + WVD method is more accurate than several other current methods, as its error is only 0.48%, and thus this method enables the practical location of cable faults. In sum, these findings demonstrate that the NCS and the FVMD + WVD method comprise an improved system for the detection and location of cable faults, which will enhance c-ble safety in power systems.

Research on underground cable abnormal vibration identification technology based on multi-model fusion

Multiparameter Identification of Bridge Cables Using XGBoost Algorithm

Fault Detection and Isolation Methods in Subsea Observation Networks

Distributed Optical Fiber Intrusion Warning Based on Multi-model Fusion

Self-Optimized Vibration Localization Based on Distributed Acoustic Sensing and Existing Underground Optical Cables

Fault Identification and Localization of a Time-Frequency Domain Joint Impedance Spectrum of Cables Based on Deep Belief Networks

An underground fiber cable discrimination method based on laser interferometer

Fault Diagnosis of Subway Mechanical Equipment Based on 5G Intelligent Sensor Network Signal Processing

VMD and self-attention mechanism-based Bi-LSTM model for fault detection of optical fiber composite submarine cables

High-Voltage Cable Buffer Layer Ablation Fault Identification Based on Artificial Intelligence and Frequency Domain Impedance Spectroscopy

Target-free recognition of cable vibration in complex backgrounds based on computer vision

Model-free underground cable incipient fault location using two-terminal zero-sequence measurements

A Novel Traveling-Wave-Based Method Improved by Unsupervised Learning for Fault Location of Power Cables Via Sheath Current Monitoring.

Research on multi-physical field analysis and assessment technique of virtual connection defects in cluster cable joints based on digital twin technology

A Double-Terminal Traveling-Wave-Based Method Using Novel Noncontact Sensors for Fault Location in Transmission Cable Lines

Cable Incipient Fault Identification Method Using Power Disturbance Waveform Feature Learning

Deep learning-based fault detection and location in underground power cables using resonance frequency analysis

Underground Power Cable Fault Detection and Localization Based on the Spectrum of Propagation Functions

A Novel Method for Identifying Cable Defect and Improving Location Accuracy Based on Frequency Domain Reflectometry

Online automatic monitoring of abnormal vibration of stay cables based on acceleration data from structural health monitoring

Cable-Partial-Discharge Recognition Based on a Data-Driven Approach with Optical-Fiber Vibration-Monitoring Signals