Abstract:This study characterized the coagulation properties and defined the cutting window (CW; time between storage modulus values of 35 and 70 Pa) using rheometry for milk standardized to 4, 5, or 6% protein and set at 28, 32, or 36°C. Milks were standardized to a protein-to-fat ratio of approximately 1 by blending ultrafiltration retentate, skim milk, and whole milk. The internal curd microstructure for selected curd samples was analyzed with transmission electron microscopy and scanning electron microscopy. Lowering the coagulation temperature caused longer rennet coagulation time and time to reach storage modulus of 35 Pa, translating into a wider CW. It also led to a lower maximum curd-firming rate (MCFR) with lower firmness at 40 min at a given protein level. Increasing protein levels resulted in the opposite effect, although without an effect on rennet coagulation time at a given temperature. On coagulation at 28°C, milk with 5% protein resulted in a similar MCFR (∼4 Pa/min) and CW (∼8.25 min) compared with milk with 4% protein at 32°C, which reflects more standard conditions, whereas increasing milk to 6% protein resulted in more than doubling of the curd-firming rate (MCFR = 9.20 Pa/min) and a shorter CW (4.60 min). Gels set at 28°C had lower levels of rearrangement of protein network after 40 min compared with those set at 36°C. Protein levels, on the other hand, had no influence on the levels of protein network rearrangement, as indicated by loss tangent values. The internal structure of curd particles, as investigated by both scanning electron microscopy and transmission electron microscopy, appeared to have less cross-linking and smaller casein aggregates when coagulated at 28°C compared with 36°C, whereas varying protein levels did not show a marked effect on aggregate formation. Overall, this study showed a marked interactive effect between coagulation temperature and protein standardization of milk on coagulation properties, which subsequently requires adjustment of the CW during cheesemaking. Lowering of the coagulation temperature greatly altered the curd microstructure, with a tendency for less syneresis during cutting. Further research is required to quantify the changes in syneresis and in fat and protein losses to whey due to changes in the microstructure of curd particles arising from the different coagulation conditions applied to the protein-fortified milk.

Factors affecting the coagulation of milk protein during quark cheese processing in Vietnam

Study on Optimization of Quarks Cheese Processing Parameters

Short communication: Influence of intramuscular injection of vitamin B 12 in early-lactation dairy cows on Mozzarella cheese quality and vitamin B 12 stability.

Effect of supercritical carbon dioxide on protein structure modification and antimicrobial peptides production of Mongolian cheese and its in vitro digestion

Cow milk coagulation: process description, variation factors and evaluation methodologies. A review

Effects of kappa-casein variants on buffalo milk protein processing properties and Mozzarella cheese quality

Cold-Renneted Milk Powders for Cheese Production: Impact of Casein/Whey Protein Ratio and Heat on the Gelling Behavior of Reconstituted Rennet Gels and on the Survival Rate of Integrated Lactic Acid Bacteria

Influence of protein concentration and coagulation temperature on rennet-induced gelation characteristics and curd microstructure

Functionality and physico-chemical characteristics of bovine and caprine mozzarella cheeses during refrigerated storage

Comparative analysis of the quality of buffalo milk fresh cheese processed with Moringa oleifera seed milk coagulant and calf rennet

Selection and study on technological parameters of symbiotic starter cultures Lactobacillus bulgaricus and Streptococcus thermophilus for production of Vietnamese yogurt

Production of Naturally γ-Aminobutyric Acid-Enriched Cheese Using the Dairy Strains Streptococcus thermophilus 84C and Lactobacillus brevis DSM 32386

Isolation and identification of milk-clotting proteases from Prinsepia utilis Royle and its application in cheese processing

Quantifying thermally induced flowability of rennet cheese curds

Understanding the role of pH in cheese manufacturing: general aspects of cheese quality and safety

The Effect of the Ratio of Gamma Aminobutyric Acid-Producing Saccharomyces cerevisiae DL6-20 and Kluyveromyces marxianus B13-5 Addition on Cheese Quality

Influence of Processing Conditions on Reducing Γ-Aminobutyric Acid Content During Fortified Milk Production

Effect of some current enzymes on milk coagulation indicators

Real-time evaluation of individual cow milk for higher cheese-milk quality with increased cheese yield

The Diversity and Proteolytic Properties of Psychrotrophic Bacteria in Raw Cows' Milk from North China

Production of Soft Bloomy Rind Cheese with Lactic Acid Bacteria Isolated from Cameroon’s Cow Milk