Effects of MEA Type and Curing Temperature on the Autogenous Deformation, Mechanical Properties, and Microstructure of Cement-Based Materials
Hua Li,Zecong Zhou,Yang Wang,Yujiang Wang,Qian Tian,Li,Zhou,Wang,Wang,Tian
DOI: https://doi.org/10.3390/ma16165651
IF: 3.4
2023-08-17
Materials
Abstract:MgO expansive agent (MEA) has the potential to meet the shrinkage compensation demands for concrete in different types of structures due to its designable reactivity and expansion properties. This study investigated the impact of three types of MEAs with different reactivities as well as curing temperature on the autogenous deformation, mechanical properties, and the microstructure of cement-based materials. The results showed that MEA type R exhibits a faster and larger hydration degree and expansion in cement mortars than MEA type M or type S in early ages under 20 °C, while when the curing temperature increases to 40 °C and 60 °C, MEA type M and type S present with significant accelerations in the hydration degree, leading to accelerated expansion rates and significantly increased expansion values compared to MEA type R. Under 40 °C, 5% MEA type M and type S present with 2.2 times and 1.1 times higher expansion in mortars than 5% MEA type R, respectively, and 8% MEA type M and type S present with 7.1 times and 5.6 times higher expansion in mortars than 8% MEA type R, respectively. Under 60 °C, 5% MEA type M and type S present 4.0 times and 3.1 times higher expansion in mortars than 5% MEA type R, respectively, and 8% MEA type M and type S present 7.0 times and 6.6 times higher expansion in mortars than 8% MEA type R, respectively. However, the increase in porosity, especially for large pores with pore size greater than 50 nm as well as the microcracks induced by the 8% dosage of MEA type M, type S, and high curing temperature of 60 °C, result in a decrease in strength of about 30% for the cement mortars. The results indicate that MEA type R is more suitable for shrinkage compensation of cement-based materials with lower temperatures, while MEA type M and type S are more suitable for shrinkage compensation of cement-based materials with higher temperatures. Under high-temperature and low-constraint conditions, the dosage of MEA needs to be strictly controlled to prevent negative effects on the microstructure and strength of cement-based materials.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering