Abstract:<p>Billions of wireless sensing devices must be powered for IoT applications. Collecting energy from the ambient environment to power sensor nodes is a promising solution. Solar energy has been one of the main sources of ambient energy due to its availability, higher power density, and the maturity of the solar photovoltaic industry. However, there are many scenarios (indoor environment, outdoor environment during nighttime, poor weather conditions, underground, etc) where ambient solar energy is either not available or not sufficient for practical applications. For such scenarios, other renewable sources of energy must be sought. Typically, not enough power is collected from one ambient source to charge sensor nodes for continuous operation. In this work, we present a multi‐source energy harvester that collects RF and thermal energy (both available 24 hours) from the ambient environment simultaneously. The RF energy harvester is multi‐band and collects power from GSM (900, 1800 MHz) and 3G (2100 MHz). The thermal harvester converts diurnal temperature fluctuations to electrical energy using high thermal effusivity phase change material. Extensive field testing has been performed in three different conditions—outdoors, indoors, and buried underground—to highlight the usefulness of the multi‐source energy harvester in all these environments. When one source is disabled, the harvester still generates energy from the remaining active source and can enable continuous operation of futuristic IoT sensors. As a proof of concept, a real‐world IoT application is demonstrated, where temperature and humidity sensors are powered by the multi‐source energy harvester. Continuous robust operation of the sensors and wireless data transmission after each 3.7 seconds are expected when both harvesters operate in full mode. Scenarios, where only single thermal energy harvester or only single RF energy harvester operates, are also demonstrated and data transmission with average time intervals of 30 seconds and 9 minutes is achieved, respectively.</p>

A hybrid energy supply system based on metamaterial antenna integrated solar cells for IoT nodes

Investigation of Self-Powered IoT Sensor Nodes for Harvesting Hybrid Indoor Ambient Light and Heat Energy

A hybrid solar‐RF energy harvesting system based on tree‐shaped antenna array

WiFi Energy-Harvesting Antenna Inspired by the Resonant Magnetic Dipole Metamaterial

Highly Efficient Broadband Ambient Energy Harvesting System Enhanced by Meta-Lens for Wirelessly Powering Battery-less IoT Devices

Compact metamaterial-integrated wireless information and power transfer system for low-power IoT sensors

Dual-band RF energy harvesting for low-power IoT devices

A hybrid solar and RF energy harvester for applications of self-Powered wireless sensor nodes

Flexible and Wearable Hybrid RF and Solar Energy Harvesting System

Multi‐source ambient energy harvester based on RF and thermal energy: Design, testing, and IoT application

A multi-frequency and multi-mode metasurface energy harvester for RF energy harvesting

Metasurface: Enhancing Gain of Antenna and Energy Harvesting System Design

Renewable energy harvesting and absorbing via multi-scale metamaterial systems for Internet of things

Energy Harvesting Using a Low-Cost Rectenna for Internet of Things (IoT) Applications

Rectenna System Development Using Harmonic Balance and S-Parameters for an RF Energy Harvester

Hybrid Energy Harvester Based on Dual Band Transparent Dielectric Resonator Antenna

Hybrid Microwave/Solar Energy Harvesting System Using 3D-Printed Metasurfaces

Design, Development and Deployment of Low-Cost Short-Range Self-Powered Wireless IoT Devices

A Scalable, Wide-Angle Metasurface Array for Electromagnetic Energy Harvesting

Compact Antenna Integrated with a Greinacher Voltage Multiplier for Ambient Energy Harvesting Applications

A Compact Multi-Mode Antenna Design Based on Metasurface for Wideband Applications