Abstract:Due to the high level of population of the Indonesian citizen affecting the necessities of the Indonesian citizen, one of which is the needs for electricity., the government through the Ministry of Energy and Mineral Resources made PERMEN ESDM number 7 of 2015 concerning the application of minimum energy performance standards and the inclusion of energy-saving labeling for air conditioning (AC) equipment that refers to SNI 19 -6713-2002 and adapted from ISO 5151. The performance of testing method that used in this system is the air enthalpy method. In using the air enthalpy method requires an isolated test chamber to reach the required temperature (°C) and humidity (% RH), the rooms called psychometric chamber. The standard condition for testing the indoor air conditioning room (evaporator) is 27°C with 47% of RH while, the standard for the air inside outdoor conditioning room (condenser) is 35°C and the % RH is not required for the test. The tool that used to control temperature and humidity in the room is an Air Handling Unit (AHU) which consists of a filter, cooling coil, humidifier, coil heater, and air blower. The AHU filter is used to filter the airs that enter the AHU. AHU which is used is connected to Chiller to regulate the temperature of the water flowing on the cooling coil and heating coil using a heat recovery system which aims to control the air temperature that will flow to the testing room by adjusting the percentage of opening area of the motorized valve that connected to the coils. The humidifier that installed inside AHU splashes water to increase the humidity of the air that will enter the heating coil. The temperature and the humidity of air that has been conditioned are blown into the room with blower. The parameters that used for this conditioning room are variable storage capacity, humidification, and heating capacity.

Incubator Analyzer Function Test in Laboratory Scale: Temperature Uniformity, Relative Humidity, Noise Level and Airflow

Design of Temperature Testing System in Multi-Parameter Combined Environmental Test

COMPARISON OF K-TYPE AND T-TYPE THERMOCOUPLES FOR STABILITY AND UNIFORMITY OF INFANT INCUBATOR TEMPERATURE TESTING BASED ON IEC 60601-2-19

Analysis of temperature stabilization in grashof incubator with environment variations based on Indonesian national standard (SNI)

Sistem Informasi Suhu dan Kelembaban Inkubator Telur Ayam Menggunakan Sensor Dht22 Berbasis Mikrokontroler

The Development of an Egg Incubator Prototype with the Use of Heat on the Condenser Side of the Refrigerator

Research on Maintenance and Quality Control of Infant Incubator

Development and Performance Study of Temperature and Humidity Regulator in Baby Incubator Using Fuzzy-PID Hybrid Controller

Electrical Safety Testing for the Infant Incubator

Portable Microplate Analyzer with a Thermostatic Chamber Based on a Smartphone for On-site Rapid Detection

Egg Incubator Temperature and Humidity Control Using Fuzzy Logic Controller

An enhancement to the FLC-based baby incubator system using genetic algorithm

Design and construction of indoor air handling unit of a psychrometric chamber for split air conditioner testing

SMART EGG INCUBATOR BASED ON MICROCONTROLLER: A REVIEW

Design of a Constant-Temperature Incubator for Paper Strip Contamination Detection

Implementation of IoT of an Electric Infant Warmer to Prevent Hypothermia in Newborns

Infant Warmer with Digital Scales for Auto Adjustment PID Control Parameters

Infant Warmer Design with PID Control for Stability and Equal Temperature Distribution Equipped with Digital Scales for Prevention of Hypothermia in Newborns

Low Cost and Portable Laboratory Kit for Practicum Learning of Air Conditioning Process in Vocational Education

Prototipe Dehumidifier untuk Monitoring Kelembaban Laboratorium Biomedis Menggunakan Sensor DHT22 dan Peltier TEC1-12706 Berbasis Arduino

Semi-Automatic Egg Incubator