Abstract:Excessive burning of fossil fuels for energy production has led to an exponential increase in CO 2 concentrations in the atmosphere, which is the core of universal problems such as global warming and climate change. One of the new approaches to reducing CO 2 emissions is to think of CO 2 as a useful raw material and convert this compound into useful products. Moreover, electrocatalytic carbon dioxide reduction (eCO 2 R) can be conveniently utilized to establish a zero-emission carbon cycle and utilize this CO 2 for energy-dense fuels and other chemical raw materials [1]. However, exploring novel catalysts is the ultimate need of the hour for an effective and efficient eCO 2 R. Heterogeneous single-atom catalysts (SAC) containing isolated metal species on an atomic level are gaining the increasing attention of the scientific community owing to their high metal utilization sites and superior catalytic properties[2]. The SACs are put into the full effect of catalysis by scattering it over conductive support. Therefore, in this work, the copper SACs are supported over a unique porphyrin-based graphdiyne (SAC-PG) with a π-conjugated structure (Figure 1). Graphdiyne possesses two acetylenic linkages between the aromatic rings and is responsible for not only displaying exceptional electronic conductivity but when coupled with the metalloporphyrin network provides numerous active sites for catalysis[3]. This SAC-PG analogue is achieved by a Glaser-Hay coupling reaction on Cu foam or foil. Moreover, SEM analysis is performed in combination with SEM-EDX and elemental mapping to investigate the morphology of the fabricated catalyst (Figure 2). In addition, this unique copper-based SAC-PG is evaluated as a catalyst for eCO 2 R in a customized H-cell with 0.1M/0.5M KHCO 3 as an electrolyte and Pt as a counter electrode. Nafion 117 proton exchange membrane is used for separation between the cathodic and anodic compartments while an Ag/AgCl (3M KCl) was used as a reference electrode. Under these eCO 2 R conditions, the copper SAC-PG catalyst displayed extremely high current densities (32 – 75 mA/cm 2 ) over a range of voltages (1.0-1.2 V vs RHE) and acceptable faradaic efficiencies for the carbon products (with maximum FE over 60% in total for all carbon products). In conclusion, a 2D metal covalent organic framework containing a repeating unit of Cu-porphyrin linked by butadiyne linkages was established. This unique structure showed effective CO 2 R catalysis due to its nanoporous structure, high electronic conductivity, and abundant metal cites utilization. Further optimization and constriction of these easily adjustable catalysts open up various possibilities of further exploration in the field of eCO 2 R. Acknowledgement : The author Zubair Masaud acknowledges support from the Norwegian Micro- and Nano-Fabrication Facility (NorFab, No. 245963/F50) The author Hao Huang acknowledges Marie Skłodowska-Curie Actions individual fellowship CarbonChem 101024758. References [1] I. Ganesh, “Electrochemical conversion of carbon dioxide into renewable fuel chemicals - The role of nanomaterials and the commercialization,” Renew. Sustain. Energy Rev. , vol. 59, pp. 1269–1297, 2016, doi: 10.1016/j.rser.2016.01.026. [2] X. Yang, A. Wang, B. Qiao, and J. U. N. Li, “Single-Atom Catalysts : A New Frontier,” vol. 46, no. 8, 2013. [3] C. Huang et al. , “Progress in Research into 2D Graphdiyne-Based Materials,” Chem. Rev. , vol. 118, no. 16, pp. 7744–7803, 2018, doi: 10.1021/acs.chemrev.8b00288. Figure 1

Fabrication of Cu-Single Atom Catalyst Supported on Unique 2D Graphdiyne Analogue-Based Porphyrin Metal Covalent Organic Frameworks for Carbon Dioxide Reduction Application

Graphene-Based Single-Atom Catalysts for Electrochemical CO2 Reduction: Unraveling the Roles of Metals and Dopants in Tuning Activity

Metal-organic Framework Derived Single-Atom Catalysts for Electrochemical CO2 Reduction

Insights on forming N,O-coordinated Cu single-atom catalysts for electrochemical reduction CO2 to methane

Enhanced CO2 Reduction on a Cu-Decorated Single-Atom Catalyst via an Inverse Sandwich M-Graphene-Cu Structure

Heteronuclear Dual Single-Atom Catalysts for Ambient Conversion of CO 2 from Air to Formate

Non‐Aqueous Electrochemical CO2 Reduction to Multivariate C2‐Products Over Single Atom Catalyst at Current Density up to 100 mA cm−2

C2N-graphene supported single-atom catalysts for CO2 electrochemical reduction reaction: mechanistic insight and catalyst screening

Electrochemical CO2 Reduction Using a Free-Standing Porous Cu Framework as Catalyst

Metal Single-Atom Coordinated Graphitic Carbon Nitride As an Efficient Catalyst for CO Oxidation

Single‐Atom Electrocatalysts from Multivariate Metal–Organic Frameworks for Highly Selective Reduction of CO2 at Low Pressures

Single‐Layered Imine‐Linked Porphyrin‐Based Two‐Dimensional Covalent Organic Frameworks Targeting CO2 Reduction

Tailoring Microenvironments and In Situ Transformations of Cu Catalysts for Selective and Stable Electrosynthesis of Multicarbon Products

Cu Single-Atom Electrocatalyst on Nitrogen-Containing Graphdiyne for CO2 Electroreduction to CH4

Grain Boundary-Rich Copper Nanocatalysts Generated from Metal-Organic Framework Nanoparticles for CO2 -to-C2+ Electroconversion

A 2D Porous Cu3N Catalyst for Efficient CO Electroreduction to Multicarbon Products at an Ampere Level Current Density

Design of Graphdiyne and Holey Graphyne‐Based Single Atom Catalysts for CO2 Reduction with Interpretable Machine Learning

Fully Exposed Copper Single-Atom Sites on Mesoporous N/S-Codoped Graphene for Efficient Zinc-Air Battery

Metal–organic framework derived single-atom catalysts for electrochemical CO 2 reduction

Standing Carbon‐Supported Trace Levels of Metal Derived from Covalent Organic Framework for Electrocatalysis

Porphyrinic Mof-Derived Rich N-Doped Porous Carbon with Highly Active Con4c Single Atom Sites for Enhanced Oxygen Reduction Reaction and Zn-Air Batteries Performance